ProForm 760 Make sure that the power cord is unplugged, Do not fully fold the Frame yet

1. Make sure that the power cord is unplugged.	1
With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (56) so that the treadmill is more stable;			38	Hole
do not fully fold the Frame yet.				83
Cut the tie securing the Upright Wire (38) to the		Tie		81
Base (83). Locate the tie in the indicated hole in
the Base, and use the tie to pull the Upright Wire
out of the hole.				2
Attach a Base Pad (81) to the Base (83) in the
location shown with a Base Pad Spacer (13) and
a #8 x 1" Tek Screw (2). Then, attach another		13
Base Pad (81) with only a #8 x 1" Tek Screw (2).	56		81
			2
2. Attach a Wheel (84) with a 3/8" x 2" Shoulder	2
Bolt (111) and a 3/8" Nut (8). Do not over-
tighten the Nut; the Wheel must turn freely.
			83
		111
		8	84
3. Identify the Right Upright (78) and the Right	3
Upright Spacer (79), which are marked with
	38
stickers. Insert the Upright Wire (38) through the
Right Upright Spacer as shown.				78
See the inset drawing. Tie the long tie in the		Long Tie		38
Right Upright (78) securely around the end of
				79
the Upright Wire (38). With the help of a second
				83
person, hold the Right Upright near the Base
(83). Then, pull the other end of the long tie until
the Upright Wire is routed completely through
the Right Upright.
		78
	38	Wire
		Tie
	7