1CONSOLE MAST
1.Feed the computer cable (95) up through the console mast tube (pulse grip posts at the top) with the end of the twist tie that is attached to it.
2.Place the console mast tube onto the mating plate of the main frame; Be careful not to pinch the Computer cable between the console mast and the main frame plates during assembly.
3.Secure the console mast in place with the four stainless steel bolts (42) and split washers (50). Make sure the bolts are securely tightened using the 8mm Allen wrench (108).
4.Attach the console (78) to the bracket with four Phillips Head Screws (112) using the Phillips Head Screw Driver (107).
5.Attach the hand brake lever (90) to the handlebars as follows:
Remove the screw that is threaded into the nut on the backside of the hand brake with the
Phillips head screw driver (107)
Place the hand brake bracket around the front of the right handlebar vertical tube, then insert the bolt through the back of the bracket and thread back into the nut. Tighten with the Phillips head screw driver (107)
HARDWARE
#42. M10 x 20mm | #50. M10 | #112. M5 x 12mm |
Stainless Steel Bolt | Split Washer | Phillips Head Screw |
(4 pcs) | (4 pcs) | (4 pcs) |
XG400 Elliptical | 6 |