1.
To make assembly easier, read the information on page 5 before you begin assembling the elliptical exerciser.
Attach the Rear Stabilizer (35) to the Frame (1) with two M10 x 75mm Carriage Bolts (58) and two M10 Nylon Locknuts (84).
Press the Stabilizer Endcaps (36) onto the Rear Stabilizer (35) as shown.
2.Attach the Front Stabilizer (3) to the Frame (1) with two M10 x 76mm Button Bolts (74), two M10 Split Washers (78), two Concave Spacers (90), and two M10 Nylon Locknuts (84). Do not tighten the
Nylon Locknuts yet.
Thread two M10 x 60mm Button Screws (89) with two M10 Split Washers (78) and two Concave Spacers (90) through the Front Stabilizer (3) and into the Frame (1). Tighten the two M10 Nylon
Locknuts (84), and then tighten the Button Screws.
Orient a Wheel (28) so the four posts (see the inset drawing) are facing away from the Front Stabilizer
(3).Attach the Wheel to the Front Stabilizer with an
M8 Nylon Locknut (59). Next, press a Wheel Cover
(29)onto the posts on the Wheel. Attach the other Wheel (not shown) in the same way.
3.While another person holds the Upright (2) near the Frame (1), connect the Upper Wire Harness (18) to the Lower Wire Harness (38).
Carefully slide the Upright (2) onto the Frame (1).
Be careful to avoid pinching the Wire Harnesses (18, 38). Attach the Upright with four M8 x 19mm Patch Screws (73) and four M8 Split Washers (79).
Do not tighten the Patch Screws yet.
1 |
|
|
|
|
| 58 | 36 |
|
|
| |
|
| 1 |
|
35 |
|
|
|
36 |
|
|
|
|
| 84 |
|
2 |
|
|
|
28 |
|
|
|
Posts |
| 74 |
|
|
|
| |
| 78 | 78 |
|
|
|
| |
| 90 | 90 |
|
|
|
| |
29 |
| 1 |
|
3 | 90 |
|
|
28 | 78 |
|
|
89 |
|
| |
59 |
|
| |
84 | 90 |
| |
|
| ||
|
| 78 | 89 |
3 | 79 |
|
|
2 |
|
| |
| 73 |
| |
|
|
| |
79 | 79 |
| |
73 |
| 73 |
|
18 |
|
| |
|
|
| |
38 | 1 |
|
|
|
|
| |
6