ProForm PFEL3226.0 specs

7. Attach the Left Pedal Arm (21) to the left Upper	7
Body Arm (6) with an M8 x 25mm Patch Screw	7
Body Arm (6) with an M8 x 25mm Patch Screw
(70), an M8 Washer (64), and a Pedal Leg Cover		6
(23).		6
(23).
Apply grease to a Large Wave Washer (20) and		73
slide it onto the Left Crank Arm (42). Then, attach
the Left Pedal Arm (21) to the Left Crank Arm with		21
an M8 x 25mm Patch Screw (70) and an M8 Large		21
an M8 x 25mm Patch Screw (70) and an M8 Large	64
Washer (81).	64
Washer (81).
Repeat this step for the other side of the elliptical	70	23	20
exerciser.	70		20
exerciser.			81
See step 3. Tighten the four M8 x 19mm Patch		70	81
See step 3. Tighten the four M8 x 19mm Patch
Screws (73).
8. The Console (10) requires four “D” batteries (not	8
included); alkaline batteries are recommended.	8
included); alkaline batteries are recommended.
Remove the battery cover from the Console. Insert
four batteries into the Console; make sure that the
batteries are oriented as shown by the markings
inside of the battery compartment. Then, reattach
the battery cover.

10	Batteries

Battery

Cover

9.While another person holds the Console (10) near the Upright (2), connect the Upper Wire Harness (18) to the wire harness on the Console.

Attach the Console (10) to the Upright (2) with four M4 x 16mm Screws (60). Be careful not to pinch the wire harnesses.

Attach the Water Bottle Holder (17) to the Upright (2) with two M4 x 22mm Screws (66).

6017