4.Identify the Left Pedal Arm (21), which is marked with a sticker. Attach a Pedal (19) to the Left Pedal Arm with three M4 x 19mm Screws (68) and three Star Washers (85).
Attach the other Pedal (not shown) to the Right Pedal Arm (not shown) in the same way.
5.Apply a generous amount of grease to the Pivot Axle
(16).Then, apply a small amount of grease to two Wave Washers (27).
While another person aligns the Upper Body Legs (6) with the Upright (2) as shown, insert the Pivot Axle
(16)into the Upper Body Legs and the Upright. Be careful not to damage the Upper Wire Harness
(18)with the Pivot Axle.
Place a Wave Washer (27) on each end of the Pivot Axle (16). Then, tighten an M8 x 23mm Button Screw (65), an M8 Washer (64), and a Pivot Cover (14) into each end of the Pivot Axle.
6.Apply a generous amount of grease to the axle on the left Upper Body Leg (6). Then, apply grease to a Large Wave Washer (20) and slide it onto the axle.
Apply a generous amount of grease to the Left Crank Arm (42). Then, slide a Crank Arm Spacer (45) onto the Left Crank Arm.
Slide the Left Pedal Arm (21) onto the left Upper Body Leg (6) and onto the Left Crank Arm (42).
Repeat this step for the other side of the elliptical exerciser.
7
4 |
|
|
|
|
|
| 19 |
| 21 |
|
|
|
| 85 | 85 |
|
|
| |
|
|
| 68 |
5 |
| 18 | 65 |
|
| ||
|
|
| 14 |
|
|
| Grease |
| 2 |
| 64 |
|
| 27 | |
|
|
| |
| Grease |
| 16 |
27 |
|
| |
64 |
|
| 6 |
|
|
| |
65 | 14 | 6 |
|
6 |
|
|
| 6 |
|
| Grease | 42 |
Grease | 45 |
|
20 |
| |
|
| |
| 21 |
|