3.Tip: Be careful not to pinch the Wire Harnesses (97, 54) during this step. Start all screws before tightening any of them.
While a second person holds the Upright (6) near the Frame (1), connect the Upper Wire Harness (97) to the Lower Wire Harness (54).
Attach the Upright (6) to the Frame (1) with five 5/16" x 1" Patch Screws (81) and five 5/16" Split Washers (105).
4.Apply a generous amount of the included grease to the Pivot Axle (33) and to two 5/8" Wave Washers (102).
Tip: Avoid pinching or damaging the Upper Wire Harness (97). Insert the Pivot Axle (33) through the Upright (6). Then, slide a 5/8" Wave Washer (102) onto each end of the Pivot Axle.
Slide an Upper Body Arm (12) onto the left side of the Pivot Axle (33). Attach the Upper Body Arm with a 5/16" x 1" Patch Screw (81), a Large Axle Cover (94), and a 5/16" Washer (104).
Attach the other Upper Body Arm (12) in the same way.
3
Avoid pinching the Wire Harnesses (97, 54) during this step
| 6 |
|
|
|
| 97 |
|
81 |
| 54 |
|
|
| 1 |
|
105 |
| 105 |
|
81 |
|
| |
|
|
| |
|
| 81 |
|
4 |
|
|
|
104 | 97 |
|
|
81 |
|
|
|
94 |
|
|
|
102 |
| Grease |
|
Grease |
| 104 |
|
12 | 6 | 94 | |
33 |
| ||
|
| 81 | |
|
| 102 | |
|
|
| |
|
| 12 |
|
7 |
|
|
|