23.Remove the 3/8Ó Nylon Locknut (50) attached to the 3/8Ó x 5Ó Bolt (42) in step 19. Wrap the High Cable (73) around a 3 1/2Ó Pulley (35) in the direction shown.
Slide the 3 1/2Ó Pulley (35) and a Cable Trap (44) onto the 3/8Ó x 5Ó Bolt (42) that was attached to the Top Frame (1) in step 19. Secure the Pulley and Cable Trap with a 3/8Ó Nylon Locknut (50). Note:
Before you tighten the 3/8Ó Nylon Locknut, make sure the High Cable (73) rests in the grooves of both of the Pulleys (35) attached to the Top Frame
(1). Make sure both Cable Traps (44) are oriented as shown in this step and in step 19.
24.
Wrap the High Cable (73) around one of the removed 3 1/2Ó Pulleys (35) in the direction shown.
Attach the 3 1/2Ó Pulley (35) and a Cable Trap (44) to the Pulley Plates (31) with a 3/8Ó x 2Ó Bolt (62) and a 3/8Ó Nylon Locknut (50).
25.Wrap the High Cable (73) around a 3 1/2Ó Pulley (35) in the direction shown.
Attach the 3 1/2Ó Pulley (35) to the bracket on the Top Frame (1) with a 3/8Ó x 2Ó Bolt (62) and a 3/8Ó Nylon Locknut (50).
26.Thread the bolt at the end of the High Cable (73) a couple of turns into the top of the Weight Tube (77). This is to prevent the High Cable from falling down during the following steps. It will be permanently attached in step 36.
23 |
| 73 |
|
| |
|
| 42 |
|
| 1 |
35 |
|
|
50 | 44 |
|
|
| |
24 |
|
|
| 73 |
|
44 | 35 |
|
|
| |
50 |
|
|
Holes |
| 62 |
31 |
| |
|
| |
25 | 1 | 62 |
|
| 35 |
|
| 73 |
Bracket |
|
|
50 |
|
|
26 |
|
|
| 73 |
|
| 77 |
|
12