ProForm PFSY92080 manual

31.Wrap the Low Cable (72) around a 3 1/2Ó Pulley (35) in the direction shown. Slide the Pulley and a Cable Trap (44) onto a 3/8Ó x 4 3/4Ó Bolt (65). Slide the Bolt into the indicated hole in the bracket on the Butterfly Upright (2). Thread a 3/8Ó Nylon Locknut (50) a cou- ple of turns onto the Bolt to prevent it from sliding out during the following steps.

32.Wrap the Low Cable (72) around a 3 1/2Ó Pulley (35) in the direction shown.

Attach the Pulley (35) and a Cable Trap (44) to the lowest of the two holes in the Pulley Plates (31) hang- ing from the High Cable (73). Secure the Pulley and Cable Trap with a 3/8Ó x 2Ó Bolt (62) and a 3/8Ó Nylon Locknut (50).

Make sure the Cable Trap is oriented as shown and that it is mounted between the Pulley Plates.

33.Remove the 3/8Ó Nylon Locknut (50) that was thread- ed onto the 3/8Ó x 4 3/4Ó Bolt (65) in step 31.

Wrap the Low Cable (72) around a 3 1/2Ó Pulley (35) in the direction shown. Slide the Pulley and a Cable Trap (44) onto the 3/8Ó x 4 3/4Ó Bolt (65). Secure the Pulley with a 3/8Ó Nylon Locknut (50).

Make sure both Cable Traps attached to the 3/8Ó x 4 3/4Ó Bolt (65) are oriented as shown in this step and in step 31.

34.Wrap the Low Cable (72) around a 3 1/2Ó Pulley (35) in the direction shown. Attach the Pulley and a Cable Trap (44) to the ÒIÓ-plates (31) hanging from the Short Cable (97). Secure the Pulley and Cable Trap with a 3/8Ó x 2Ò Bolt (62) and a 3/8Ó Nylon Locknut (50).

Make sure the Cable Trap is oriented as shown and that it is mounted between the Pulley Plates.

14

31			72
			65
			35
	50		44
			2
32			73
	31
	50
	44		62
			35
	72
33	72		2
50
	35	44	65
34			97
	50		31
			62
	44		35
			72