3.Attach the Upright (2) to the Frame (1) with three M10 x 25mm Button Head Screws (25) and three M10 Split Washers (26). Be careful not to pinch the Reed Switch Wire (13) or the Resistance Cable (10).
4.Connect the Reed Switch Wire (13) to the wire on the back of the Console (8).
Attach the Console (8) to the Upright (2) with four #8 x 5/8Ó Screws (22).
Press the Resistance Knob (9) onto the Resistance Control (10). Be sure that the mark on the Resistance Knob is correctly aligned.
5.Attach the Handlebar (4) to the Upright (2) with two M10 x 25mm Hex Head Screws (25) and two M10 Split Washers (26).
6.Attach the Seat (16) to the Seat Post (3) with four M8 Split Washers (41) and four M8 Nylon Locknuts (20).
Insert the Seat Post (3) into the Frame (1). Press the Frame Bushing (17) into place in the Frame.
Align one of the holes in the Seat Post (3) with the hole in the Frame (1). Insert the Lock Knob
(14)into the Frame and the Seat Post. Tighten the Lock Knob.
3 |
| 2 |
|
|
|
| |
| 26 | 25 |
|
|
|
| |
25 |
| 26 |
|
|
|
| |
| 26 | 10 |
|
|
|
| |
|
| 13 |
|
|
| 1 |
|
4 |
|
|
|
|
|
| 9 |
Console Wire |
|
|
|
13 |
| 8 |
|
|
|
| |
22 |
| 2 |
|
|
| 10 |
|
|
| 22 |
|
5 |
|
|
|
2 |
|
| 4 |
|
|
| |
|
| 26 | 25 |
|
|
| |
6 |
|
|
|
| 16 |
|
|
| 41 | 3 |
|
|
|
| |
| 20 | 41 |
|
|
|
| |
| 17 | 20 |
|
|
|
| |
| 1 |
|
|
|
| 14 |
|
5