11.Identify the Left Pedal (13) and the Left Pedal Leg (14), which are marked with “Left” stickers, and orient them as shown.
Attach the Left Pedal (13) to the Left Pedal Leg (14) with four M6 x 35mm Phillips Screws (87) and four M6 Split Washers (88).
Start all four Phillips Screws before tighten- ing any of them.
Repeat this step to attach the Right Pedal to the Right Pedal Leg (not shown).
12.Apply a generous amount of grease to two Pedal Leg Axles (32). Insert one Pedal Leg Axle into the bottom of the Left Handlebar Leg (11). Insert the other Pedal Leg Axle into the Left Roller Leg (12).
Apply a small amount of grease to both sides of two Wave Washers (98). Place a Wave Washer on each Pedal Leg Axle (32).
Orient the Left Pedal Leg (14) as shown, and slide it onto the Pedal Leg Axles (32). Attach the Left Pedal Leg to the Left Handlebar Leg
(11)with two M10 x 20mm Patch Screws (91), two Axle Caps (31), and two M10 x 25mm Washers (94).
Attach the Left Pedal Leg (14) to the Left Roller Leg (12) with two M10 x 20mm Patch Screws (91) and two M10 x 25mm Washers (94); do not overtighten the Patch Screws. The Legs (11, 14, 12) must pivot freely.
Repeat this step for the Right Pedal Leg (not shown).
11 |
|
13 |
|
14 |
|
88 | 88 |
| |
87 | 87 |
| |
12 |
|
11 |
|
Grease |
|
|
|
32 | 91 |
| 94 |
98 | 31 | 12 | 91 |
94 |
| ||
Grease |
| ||
|
| ||
|
|
|
32
98
31
94
9114
94 91
10