13.The Console (5) can be operated with four 1.5V “D” batteries (not included); alkaline batteries are recommended. IMPORTANT: If the elliptical exerciser has been exposed to cold temper- atures, allow it to warm to room temperature before inserting batteries into the Console. If you do not do this, the console displays or other electronic components may become damaged. Remove the battery cover and insert four batteries into the Console. Make sure that the batteries are oriented as shown at the right. Then, reattach the battery cover.
Note: The Console (5) can be operated with an optional power supply instead of batteries. To purchase a power supply, call the telephone number on the front cover of this manual. Plug one end of the power supply into the jack at the front of the elliptical exerciser. Plug the other end of the power supply into an appropri- ate outlet that is properly installed in accor- dance with all local codes and ordinances.
14.Have a second person hold the Console (5) near the Upright (6) as shown. Connect the console wire harness to the Wire Harness (48).
Connect the right wire, which has a tag attached, to the Right Controller Wire (95), which has a tag attached. Then, connect the left wire to the Left Controller Wire (110). Insert the excess wire downward into the Upright (6).
Attach the Console (5) to the Upright (6) with four M4 x 16mm
15.Attach the Left and Right Upright Covers (10, 64) to the Upright (6) with four M4 x 16mm Screws (86).
13 |
|
|
| 5 |
|
Batteries |
| |
|
| Battery |
|
| Cover |
14 |
|
|
| 5 |
|
Console Wire Harness |
| |
79 | 48 |
|
|
| Left Wire |
| 110 | Right Wire |
| 95 |
|
79 | 79 |
|
6 |
| |
|
| |
15 |
|
|
| 64 | 86 |
10 |
|
|
| 6 |
|
86 |
|
|
16.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.
11