ProForm PFEL7806.1 user manual Assembly

ASSEMBLY

To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the

included hex keys, assembly requires a Phillips screwdriver , an adjustable

wrench , and a rubber mallet .

As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre- assembled. If a part is not in the parts bag, check to see if it has been preassembled.

Star Washer	M4 x 13mm		M6 Split	M8 x 15mm x 4.5mm			M8 Split		Wave Washer
(100)–3	Washer (93)–2	Washer (88)–8			Washer (99)–4		Washer (72)–4		(98)–8
							M4 x 16mm		M4 x 16mm
M10 x 20mm x	M10 x 25mm		M8 Nylon			M10 Nylon	Self-tapping		Screw (86)–8
							Screw (79)–16
1mm Washer	Washer (94)–10		Locknut (96)–4			Locknut (97)–2
(81)–2
M6 x 35mm Phillips				M8 x 42mm Bolt					M8 x 16mm Patch
Screw (87)–8					(71)–4				Screw (82)–3
	M8 x 75mm Patch					M10 x 20mm Patch		M10 x 23mm Shoulder
	Screw (107)–4					Screw (91)–10			Screw (80)–2
M10 x 62mm Patch Bolt (89)–2						M10 x 78mm Patch Screw (90)–2
					5