NordicTrack NTL15008.5 user manual

Page 4
23. Inspect and properly tighten all parts of the incline trainer regularly.
24. Never insert or drop any object into any DANGER:opening on the incline trainer.
25.Always unplug the power cord immediately after use, before cleaning the incline trainer, and before performing the maintenance and adjustment procedures de- scribed in this manual. Never remove the motor hood unless instructed to do so by an authorized service representative. Servicing other than the procedures in this manual should be performed by an authorized service representative only.
26. The incline trainer is intended for in-home use only. Do not use the incline trainer in any commercial, rental, or institutional setting.
27. Over exercising may result in serious injury or death. If you feel faint or if you experience pain while exercising, stop immediately and cool down.

18. The incline trainer is capable of high speeds. Adjust the speed in small increments to avoid sudden jumps in speed.

19. The pulse sensor is not a medical device. Various factors, including the user's move- ment, may affect the accuracy of heart rate readings. The pulse sensor is intended only as an exercise aid in determining heart rate trends in general.

20. Never leave the incline trainer unattended while it is running. Always remove the key, unplug the power cord, and switch the reset/off circuit breaker to the off position when the incline trainer is not in use. (See the drawing on page 5 for the location of the reset/off circuit breaker.)

21. Do not attempt to move the incline trainer until it is properly assembled. (See ASSEM- BLY on page 6, and HOW TO MOVE THE IN- CLINE TRAINER on page 20.) You must be able to safely lift 45 lbs. (20 kg) to move the incline trainer.

22. Do not change the incline of the incline

trainer by placing objects under the incline

trainer.

SAVE THESE INSTRUCTIONS

 

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents QUESTIONS? Model No. NTL15008.5 Serial NoMon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Page Before YOU Begin Assembly Make sure that the power cord is unplugged See the inset drawing. Tie the wire tieEning any of them. Be careful not to pinch Upright Wire Overtighten the Tek ScrewsNot to pinch the Left Pulse Wire Washers 25 do not fully tighten the Bolts Yet BoltsSert all of the tabs. Make sure not to break Tabs Page HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the Console HOW to USE the Manual Mode Measure your heart rate if desired Turn on the fan if desiredHOW to USE a 1 Step Calorie Workout Start the walking beltHOW to USE a Random Workout HOW to USE AN Ifit Card Information Mode HOW to USE the Stereo Sound SystemHOW to Move the Incline Trainer Troubleshooting Problem The power turns off during useImportant The incline trainer Is not compatible with GFCI-equipped outletsProblem The walking belt slows when walked on TopProblem Solution Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencySuggested Stretches R0310A Key No. Qty DescriptionKey No. Qty Description Exploded Drawing A-Model No. NTL15008.5 Exploded Drawing B-Model No. NTL15008.5 Exploded Drawing C-Model No. NTL15008.5 Exploded Drawing D-Model No. NTL15008.5 Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents