Assembly

Assembly requires two persons. Set the incline trainer in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the incline trainer walking belt is coated with high-performance lubricant. During shipping, some lubricant may be transferred to the top of the walking belt or the shipping carton. This is normal and does not affect incline trainer performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex keys and your own Phillips screwdriver		and
adjustable wrench	.

Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it is preattached to one of the parts to be assembled. To avoid damaging parts, do not use power tools for assembly. Extra hardware may be included.

3/8" Star	3/8" Nut (8)–2	#8 x 1/2" Screw	#8 x 3/4"	#8 x 1" Tek
Washer (9)–6	3/8" Nut (8)–2	(12)–2	Screw (1)–8	Screw (2)–4
1/4" Flat	1/4" x 1"	5/16" x 3/4"	3/8" x 2 1/2" Bolt (4)–2
Washer	Bolt (32)–4	Bolt (6)–4
(25)–4
		3/8" x 3 1/2" Bolt (3)–4
		3/8" x 5" Bolt (7)–2