36-37
Note:You cannot delete all segments while the stopwatch is running. If nothing happens when you push and hold [STOP • RESET] check to make sure the stopwatch is stopped.
36
Timer Mode
Press [MODE] until you enter theTimer mode.
3
•Count down repeat (CR)
•Count down stop (CS)
•Count down, then count up (CU)
The timer is set at the factory to the
37
38-39
Number of cycles | Timer setting |
Time in Countdown | Elapsed time |
Repeat mode | Time of day |
|
The upper line shows the programmable timer value (initially set at 0:00:00:0) while the middle line displays the current timer counting.Time of Day clock display is at the lower line of the dis- play. “CR” indicates the current timer operating mode while the timer cycle counter is located at the upper left of the display.
Before starting the timer, enter a countdown time first.Then press [START • SPLIT] to start timer running. When the timer counts down to zero, a
38
3 second “beep…beep” sound will be generated for a timer setting within one minute; 15 second “beep…beep” sound for 1 minute to 10 minutes setting and 30 second “beep…beep” sound for over 10 minutes. Pressing any key will stop the beep sound.
Under CR operating mode, the timer value will be reloaded and count down will start again.The timer cycle counter will be increased by one and updated on the display.
Under CS operating mode, the timer, after count- ing down to 0:00’00”, will stay at 0:00’00”0 until you press [STOP • RESET] to reload the timer value.
Under CU operating mode, the timer, after counting down to 0:00’00”0, will count up and stop at 19:59’59”9.
39