52-53
Before starting again, you can reset the timer by pressing [STOP • RESET].
Speed Mode after reset.
Note: When you reset the Speed timer, the speed measurement starts again from a reset state, and all speed records in memory will be cleared (pro- vided that the storage is not under segmented run memory mode).
The Recall function is similar to chronograph recall. If segmented run memory is selected, the DATA mode can be accessed and records storing
52
both the speed and elapsed time can be retrieved.
Lap Time & Speed Recall
Similar to the Chrono Recall mode, during speed measurement or Stop state, you can press [RECALL] to recall the speed/lap memories.
The Mode message will be shown for one to two seconds as the Mode message display is displayed.
RECALL
The Speed and Lap time will be displayed on the upper and the middle lines.The lower line shows the current time counting. During Data recall, the fastest speed will be reviewed first, then the slow- est speed and average speed.
53
54-55
Further presses of [RECALL] will retrieve the memories in ascending order or reverse order depending on whether the speed measurement is stopped or under operation respectively. During Recall, the “Recall” indicator is ON.
(Note: Speed mode and Chrono mode will not run simultaneously. When Chrono mode is active, Speed mode should be in reset state and vice versa.)
Please register your new stopwatch at www.ACCUSPLIT.com/support or send this form to address on the back cover of this instruction booklet
Email (preferred)
User
See label on back of unit for details, or check
http://support.ACCUSPLIT.com
54 | 55 |