16-17
Chronograph and Recall Mode
Press [MODE] until you enter the Chrono mode.
The stopwatch can measure up to 19 hours,
59 minutes, 59.99 seconds. When you enter the Chronograph mode, the display format is as below.
16
The upper line shows the split time, the middle line shows the lap time and the accumulated elapsed time is displayed on the lower line.
Whenever the stopwatch stops running, the “STOP” indicator will be ON. Press the button [START • SPLIT] to start the stopwatch. As it runs, the current elapsed time is shown on the lower line.
Split | ° Split time |
counter | ° Lap time |
| |
| ° Cumulative time |
17
18-19
To take a current split or lap time, press [START • SPLIT].The display will look like this:
The number of split/lap times taken are shown in the upper left corner.The corresponding split and lap times are displayed on the upper and middle line. Press [START •SPLIT] again, the next split/lap time will be shown and the number of split/lap time is updated.
18
The stopwatch can store up to 500 split/lap times. The split/lap times are stored into the memory as you press [START • SPLIT] to take each split/lap time. Meanwhile, the lap and split time will be frozen for 5 seconds. After this
In addition, the fastest lap, the slowest lap, and the averages of all laps will also be recorded. As you press [STOP • RESET] to stop the chronograph, the last lap/split time will also be stored (provided that the last lap/split time is not the first lap/split time).
19