40-41
How to set the timer
Press and hold [RECALL] (S1) for 2 seconds to activate timer setting.Timer setting starts with second digits, which are shown blinking.You can press [START • SPLIT] (S3) to advance the flashing digits. Or you can press [STOP •RESET] (S2) to select other digits.The setting follows the sequence: second, minute, hour and timer operating mode (CR, CS and CU).
NOTE:You can only set Hour, Minute and Seconds. The 1/10 second cannot be set.
Press and hold [RECALL] for 2 seconds.Timer setting starts with second digits.
40
Press [STOP • RESET] (S2) to move to minute digits.
Press [STOP • RESET] (S2) further to go to hour digits.
Hour digits can be adjusted
from 0 to 19. 
Press [STOP • RESET] (S2) again to adjust the operating
mode. Press [START] to switch the operating modes among CR, CS and CU. 
At the end of setting, press [RECALL] (S4) or [MODE] to leave setting mode.
41
42-43
Pacer Mode
Press [MODE] until you enter the Pacer mode. In the Pacer mode, you can set the standard pacer speed from 5 to 240 beats per minute in the following values:
5, 10, 20, 30, 40, 50, 60, 80, 100, 120, 150, 180, 200, 240
In Pacer mode, the display will be:
PACER | ° 5 beats per minute |
P - 5 |
The digits are flashing to indicate that the pace count is ready for setting. Press [STOP • RESET] to select the pace count. Once the desired pace count is selected, press [START • SPLIT] to confirm the
42
setting and start the pace count.The display will show the elapsed time on the upper line, the pace count number on the middle and the pace count value on the lower display.
° Elapsed time
° Pace count number
° PACE count
Press [STOP • RESET] to stop the pace count; the display will freeze.To restart the
pace count, press [START • SPLIT] again. Or press [STOP • RESET] to reset the time elapsed and the pace count number .
43