JVC MX-J300 manual Connecting Speakers, Release the finger from the clamp, AM antenna

Page 12

AM antenna

1 2 3

Connecting Speakers

You can connect a pair of the front speakers.

1

2

3

	ANTENNA
	FM
FM
75	GND
AM
EXT	GND
	GND
	AM LOOP

Vinyl-covered wire (not supplied)

	Red
	CAUTION:
	SPEAKER IMPEDANCE
	6~16 OHMS
	SPEAKERS
Speaker	RIGHT	Speaker
	RIGHT	LEFT
		cord
cord		cord
cord
	Black

AM loop antenna (supplied)

1Connect the AM loop antenna to the AM LOOP terminals as illustrated.

2Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.)

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

Right	Left
speaker	speaker

1Press and hold the clamp of the speaker terminal on the rear of the unit.

2Insert the end of the speaker cord into the

terminal.

Match the polarity of the speaker terminals: Red (+) to red (+) and black (–) to black (–).

3Release the finger from the clamp.

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

– 9 –

Image 12

Contents MX-J300 MX-J200 Mises en garde, précautions et indications diverses For Canada/pour le Canada Precautions IntroductionAbout This Manual Contents Location of the Buttons and Controls CA-MXJ300Powered Rolling Panel CA-MXJ300 Front PanelDisplay Window CA-MXJ200 CA-MXJ200 Front Panel These buttons do not function as 1 / ÁRemote Control Remote ControlConnecting Antennas Getting StartedUnpacking FM antennaConnecting Speakers Release the finger from the clampAM antenna To connect an outdoor AM antennaConnecting Other Equipment Press and hold Demo for more than Seconds.DEMOTo connect audio equipment To start the display demonstration manuallySetting the Clock Common OperationsTurning On the Power and Selecting the Sources Adjusting the VolumeReinforcing the Bass Sound Selecting the Sound ModesTo select the sound modes, press Sound Surround modesTuning in a Station Tuning in a Preset StationPresetting Stations Listening to FM and AM BroadcastsPlaying Back CDs Loading CDsPlaying Back the Entire Discs Continuous Play Basic CD OperationsProgram Play Select the Random play mode On the unit To check the program contentsPlaying at Random Random Play Prepare CDsRepeating Tracks or CDs Repeat Play Prohibiting Disc Ejection Tray LockIf you try to eject CDs Playing Back Tapes Playing Back a TapeRecording Recording Tapes on Deck BPress Eject 0for the deck B Start recording On the unit Press REC START/STOPTo record on both sides Reverse Mode Dubbing TapesCD Direct Recording Press DubbingUsing the Timers Using Daily TimerWhen selecting CD When selecting Tuner FM or Tuner AMPress 4or ¢to set the volume level Press TimerUsing Recording Timer Set the volume levelTimer setting How Recording Timer actually worksTo turn on On the remote control Press Timer until REC appearsPress Power to turn off the unit on standby if necessary Put a recordable cassette into deck B Press ShiftTimer Priority Using Sleep TimerSelect the preset station On the remote control only Press SleepMaintenance Handling discsCassette decks Troubleshooting SpecificationsHOW to Locate Your JVC Service Center Limited Warranty AUDIO-1 0200KSMMDWHIT