Common Operations
Setting the Clock
Before operating the unit any further, first set the clock built in this unit.
For MX-J300 only
Press PANEL OPEN/CLOSE .
2 Press SELECT – or + to adjust the | 4 | – SELECT + |
hour, then press SET. | 5 | |
|
|
SET
8 
The unit is turned on and the Powered Rolling Panel opens automatically.
PANEL OPEN / CLOSE
• If you want to correct the hour after pressing SET, press CANCEL (on the unit). The hour digits start flashing again.
On the unit:
1Press CLOCK/TIMER.
CLOCK/TIMER
3Press SELECT – or + to adjust minute, then press SET.
the 4 | – SELECT + |
5 |
SET
8 
The hour digits start flashing on the display.
2Press 4or ¢to adjust the hour, then press SET.
– PRESET +
To check the clock time
Press DISPLAY while playing any source.
DISPLAY
•Each time you press the button, the source indication and the clock time alternate on the display.
To adjust the clock again
SET
•If you want to correct the hour after pressing SET, press CANCEL. The hour digits start flashing again.
3 | Press 4or ¢to adjust the | – PRESET + | |
|
| ||
| minute, then press SET. |
|
|
|
|
| |
|
| SET |
On the remote control: |
| |
1 | Press SHIFT. | SHIFT |
| ||
2 | Press CLOCK. | CLOCK |
|
| 1 |
The hour digits start flashing on the display.
If you have adjusted the clock before, you need to press CLOCK/TIMER repeatedly until the clock setting mode is selected.
•Each time you press the button, the clock/timer setting modes change as follows:
DAILY 
ON TIME 
REC
Canceled
Clock
ON TIME
setting
(The hour digits start flashing.)
If there is a power failure
The clock loses the setting and is reset to “AM 12:00.” You need to set the clock again.
– 11 –