JVC MX-J300 Reinforcing the Bass Sound, Selecting the Sound Modes, Surround modes, SEA modes

Page 16

Reinforcing the Bass Sound

The richness and fullness of the bass sound is maintained regardless of how low you set the volume.

You can use this effect only for playback.

To get the effect, press ACTIVE BASS EX.

ACTIVE BASE EX.

BASS

The BASS indicator also lights up on the display.

To cancel the effect, press the button again.

Selecting the Sound Modes

You can select one of the 6 preset sound modes (3 surround modes and 3 SEA – Sound Effect Amplifier – modes). The sound modes can be applied only to playback sounds, and cannot be used for recording.

To select the sound modes, press SOUND	SOUND MODE
To select the sound modes, press SOUND
MODE until the sound mode you want appears on
the display. The S. MODE indicator also lights up
on the display.

S.MODE

•Each time you press the button, the sound modes change as follows:

D.CLUB HALL STADIUM ROCK

(Dance CLUB)

OFF CLASSIC POP

(Canceled)

Surround modes:

D.CLUB: Increases resonance and bass.

HALL: Adds depth and brilliance to the sound.

STADIUM: Adds clarity and spreads the sound, like in an outdoor stadium.

SEA modes:

ROCK: Boosts low and high frequency. Good for acoustic music.

POP: Good for vocal music.

CLASSIC: Good for classical music.

OFF: Cancels the sound mode.

– 13 –

Image 16

Contents MX-J300 MX-J200 Mises en garde, précautions et indications diverses For Canada/pour le Canada Introduction PrecautionsAbout This Manual Contents Location of the Buttons and Controls CA-MXJ300CA-MXJ300 Front Panel Powered Rolling PanelDisplay Window CA-MXJ200 CA-MXJ200 Front Panel These buttons do not function as 1 / ÁRemote Control Remote ControlConnecting Antennas Getting StartedUnpacking FM antennaConnecting Speakers Release the finger from the clampAM antenna To connect an outdoor AM antennaConnecting Other Equipment Press and hold Demo for more than Seconds.DEMOTo connect audio equipment To start the display demonstration manuallySetting the Clock Common OperationsTurning On the Power and Selecting the Sources Adjusting the VolumeReinforcing the Bass Sound Selecting the Sound ModesTo select the sound modes, press Sound Surround modesTuning in a Station Tuning in a Preset StationPresetting Stations Listening to FM and AM BroadcastsPlaying Back CDs Loading CDsPlaying Back the Entire Discs Continuous Play Basic CD OperationsProgram Play Select the Random play mode On the unit To check the program contentsPlaying at Random Random Play Prepare CDsProhibiting Disc Ejection Tray Lock Repeating Tracks or CDs Repeat PlayIf you try to eject CDs Playing Back Tapes Playing Back a TapeRecording Recording Tapes on Deck BPress Eject 0for the deck B Start recording On the unit Press REC START/STOPTo record on both sides Reverse Mode Dubbing TapesCD Direct Recording Press DubbingUsing the Timers Using Daily TimerWhen selecting CD When selecting Tuner FM or Tuner AMPress 4or ¢to set the volume level Press TimerUsing Recording Timer Set the volume levelTimer setting How Recording Timer actually worksTo turn on On the remote control Press Timer until REC appearsPress Power to turn off the unit on standby if necessary Put a recordable cassette into deck B Press ShiftTimer Priority Using Sleep TimerSelect the preset station On the remote control only Press SleepHandling discs MaintenanceCassette decks Troubleshooting SpecificationsHOW to Locate Your JVC Service Center Limited Warranty AUDIO-1 0200KSMMDWHIT