JVC MX-J300 Recording Tapes on Deck B, Press Eject 0for the deck B, To protect your recording

Recording

Continued

IMPORTANT:

•It should be noted that it may be unlawful to re-record pre-recorded tapes, records, or discs without the consent of the owner of copyright in the sound or video recording, broadcast or cable programme and in any literary, dramatic, musical, or artistic embodied therein.

•The recording level is automatically set correctly, so it is not affected by the VOLUME control. Thus, during recording you can adjust the sound you are actually listening to without affecting the recording level.

•While recording, you can hear sound modes and/or the active bass extension effect through the speakers or headphones. However, the sound is recorded without these effects (see page 13).

•If recordings you have made have excessive noise or static, the unit may be too close to a TV. Increase the distance between the TV and the unit.

•You can use type I tapes for recording.

To protect your recording

Cassettes have two small tabs on the back to protect unexpected erasure or re-recording.

To protect your recording, remove these tabs.

To re-record on a protected tape, cover the holes with adhesive tape.

Recording Tapes on Deck B

1 Press EJECT 0for the deck B.

0EJECT

0EJECT

2 Put in a recordable cassette, with the exposed part of the tape down.

3 Close the cassette holder gently.

4 Check the tape direction of deck B.

•If the tape direction is not correct, press TAPE 2 3 twice then 7to change the tape direction.

•If you want to record on both sides of a tape, press

REVERSE MODE until the indicator is lit.

5 Start playing the source — FM, AM*, CD player, deck A, or auxiliary equipment connected to AUX jacks.

•When the source is CD, you can also use CD Direct Recording (see page 21).

•When the source is deck A, you can also use the dubbing method. (See “Dubbing Tapes” on page 21.)

* See “To record an AM station – Beat Cut” on page 21.

6 Start recording.

On the unit:
Press REC START/STOP.		REC
		START/STOP
The	indicator lights up on the display and
recording starts.
On the remote control:

1)Press REC PAUSE.

The indicator starts flashing on the display.

2)Press TAPE 2or TAPE 3.

The indicator stops flashing and remains lit, and recording starts.

To stop during recording, press REC START/ STOP again, or press 7.

REC PAUSE

23

TAPE

– 20 –