JVC RX-430VBK manual Selecting the Front Speakers, Adjusting the Volume, Muting the Sound

Page 16

English

Selecting the Front Speakers

When you have connected two sets of front speakers, you can select which to use. Pressing SPEAKERS 1 or SPEAKERS 2 activates the respective set of speakers.

1

2

To use the set of speakers connected to the FRONT SPEAKERS 1 terminals, press SPEAKERS 1 to set

 

SPEAKERS

 

 

it in the _ON position, and press SPEAKERS 2 to set it in the ÑOFF position.

_ON ÑOFF

To use the set of speakers connected to the FRONT SPEAKERS 2 terminals, press SPEAKERS 2 to set

it in the _ON position, and press SPEAKERS 1 to set it in the ÑOFF position.

To use both sets of speakers, press both SPEAKERS 1 and 2 to set them in the _ON position. To use neither set of speakers, press both SPEAKERS 1 and 2 to set them in the ÑOFF position.

Note:

When only one set of the front speakers is connected to either the FRONT SPEAKERS 1 or 2 terminals, do not press both SPEAKERS 1 and 2 to set them in the _ON position. If you do, no sound comes out of the front speakers.

Adjusting the Volume

MASTER VOLUME

–+

On the front panel

–VOLUME +

From the remote control

On the front panel:

To increase the volume, turn MASTER VOLUME clockwise.

To decrease the volume, turn it counterclockwise.

When you turn MASTER VOLUME rapidly, the volume level also changes rapidly. When you turn MASTER VOLUME slowly, the volume level also changes slowly.

From the remote control:

To increase the volume, press VOLUME +.

To decrease the volume, press VOLUME –.

CAUTION:

Always set the volume to the minimum before starting any source. If the volume is set at its high level, the sudden blast of sound energy can permanently damage your hearing and/or ruin your speakers.

Muting the Sound

From the remote control only:

Press MUTE to mute the sound through all speakers and headphones connected. “MUTE” appears on the display and the volume turns off.

MUTE

To restore the sound, press MUTE again so that “OFF” appears on the display.

Turn MASTER VOLUME or pressing VOLUME +/– also restores the sound at the previous volume level.

Page 11

Page 15 Page 17
Image 16
Page 15 Page 17
Contents RX-430VBK Per I’ltalia English Deutsch Français Nederlands Español Italiano Voorzichtig -- Power en STANDBY/ON RX-430VBK Table of Contents Remote Control Switches, Buttons and ControlsFront Panel Checking the Supplied Accessories Before InstallationGetting Started Connecting the FM and AM MW/LW Antennas Using the Supplied FM AntennaFM Antenna Connections AM MW/LW Antenna ConnectionsConnecting the front speakers Connecting the SpeakersConnecting the rear and center speakers Case 1 When you connect only front speakers Case 2 When you connect front speakers and a center speakerCase 3 When you connect front and rear speakers About the speaker impedance of the speakersConnecting Audio/Video Components Connecting the subwoofer speakerAudio component connections Audio Components Video ComponentsVideo component connections VCRConnecting the Power Cord Putting Batteries in the Remote ControlPlug the power cord into an AC outlet Press Power to set it in the on positionBasic Operations Turning the Power On and Off StandbySelecting the Source to Play Adjusting the Volume From the remote control onlySelecting the Front Speakers Muting the SoundListening with Headphones Recording a SourceBasic Settings Adjusting the Front Speaker Output BalanceListening at Low Volume Loudness Using the Sleep TimerSelecting the Center Speaker Size Large Small noLarge SmallUsing the One Touch Operation To store the sound settings Press ONE Touch OperationTo cancel the One Touch Operation function One Touch OperationTuning in Stations Manually Using Preset TuningStoring the preset stations Receiving Radio BroadcastsSelecting the FM Reception Mode Tuning in a Preset StationFM Auto FM MonoUsing the Preset SEA Modes Selecting Your Favorite SEA ModeMovie Sports Music SPORTS1 SPORTS2 SPORTS3Movie SPORTS2 Jazz Press Preset to select the effect levelMovie 1 Movie 2 Movie Using the Surround Processor Using JVC’s Hall SurroundWhat is surround? Prologic 3CHLOGIC HallDelay 1 Delay 2 Delay DelayPress Rear +/- to adjust the rear speaker output level Press Delay to adjust the delay timeSpeaker Arrangements for Dolby Surround This casePreparing for Dolby Surround Wide Normal PhantomIf necessary, adjust the speaker output balance as follows Left front Center Right front Speaker Rear speakersPress Test to start checking the speaker output balance Press Test again to stop the test toneUsing Dolby Surround LOGIC, Hall lights up on the displayCompu Link Remote Control System Remote Control through the Remote Sensor on the ReceiverAutomatic Source Selection Synchronized RecordingUsing the Remote Control SEA Surround Control ON/OFF Troubleshooting Problem Possible Cause SolutionSpecifications AmplifierAM MW/LW tuner FM tuner IHFGeneral EN, GE, FR, NL, SP, IT 0497OFYOTKJEM

RX-430VBK specifications

The JVC RX-430VBK is a versatile stereo receiver that has captured the attention of audio enthusiasts and casual listeners alike. Designed for those who appreciate quality sound in a compact format, this receiver comes packed with features that enhance its functionality and audio performance.

One of the main highlights of the RX-430VBK is its power output, delivering a robust 100 watts per channel. This power capacity ensures clear and dynamic sound reproduction, making it suitable for a wide range of listening environments. Whether you are enjoying music, watching movies, or gaming, the RX-430VBK provides an immersive audio experience that brings your media to life.

The receiver features a built-in AM/FM tuner, allowing users to easily access their favorite radio stations. The tuner is equipped with a preset channel memory, letting users store up to 30 stations for quick access. This feature is especially convenient for those who enjoy a mix of local and national broadcasts.

For connectivity, the JVC RX-430VBK is well-equipped with multiple inputs and outputs, including five audio inputs and a dedicated phono input for turntables. This makes it an ideal choice for vinyl enthusiasts who want to connect their record player without the need for additional preamps. Additionally, it includes a headphone jack for private listening, as well as speaker outputs that support either A or B configurations, allowing for flexible setups.

Another standout feature of the RX-430VBK is its built-in digital signal processing (DSP). This technology enables users to tailor their audio experience with various sound modes such as Hall, Jazz, and Rock, which enhance the listening experience depending on the genre. The built-in EQ further allows for fine-tuning the audio output, helping users achieve their desired sound profile.

From a design perspective, the RX-430VBK boasts a sleek and modern aesthetic that fits comfortably into most home entertainment setups. Its user-friendly interface and remote control make it easy to navigate settings and manage playback from a distance.

In summary, the JVC RX-430VBK is a powerful and feature-rich stereo receiver that caters to a broad range of audio preferences and setups. With its solid power output, versatile connectivity options, and innovative sound technologies, it stands out as a strong choice for anyone looking to enhance their audio experience at home.
Top Page Image Contents