JVC RX-430VBK manual Specifications, Amplifier

Page 36

English

Specifications

Amplifier

Output Power

At Stereo Operation

 

 

Front Channels

50 watts per channel, min. RMS, driven into 4 ohms at 1 kHz with

 

 

no more than 0.9% total harmonic distortion. (IEC268-3/DIN)

 

 

30 watts per channel, min. RMS, driven into 8 ohms at 1 kHz with

 

 

no more than 0.9% total harmonic distortion. (IEC268-3/DIN)

 

 

30 watts per channel, min. RMS, driven into 8 ohms, 40 Hz to 20

 

 

kHz with no more than 0.8% total harmonic distortion.

 

At Surround Operation

 

 

Front Channels

40 watts per channel, min. RMS, driven into 8 ohms at 1 kHz with

 

 

no more than 0.8% total harmonic distortion.

 

Center Channel

40 watts, min. RMS, driven into 8 ohms at 1 kHz, with no more

 

 

than 0.8% total harmonic distortion.

 

Rear Channels

40 watts per channel, min. RMS, driven into 8 ohms at 1kHz, with

 

 

no more than 0.8% total harmonic distortion.

Total Harmonic Distortion

 

0.8 %* at 30 watts output

(8 ohms, 1 kHz)

 

(* Measured by JVC Audio Analysis System)

Frequency Response (8 ohms)

PHONO

20 Hz to 20 kHz (±1 dB)

 

CD, TAPE, VCR, VIDEO

20 Hz to 20 kHz (±1 dB)

Audio Input Sensitivity/

PHONO (MM)

2.5 mV/47 k ohms

Impedance (1 kHz)

CD, TAPE, VCR, VIDEO

200 mV/47 k ohms

Audio Output Level

TAPE, VCR

200 mV

Signal-to-Noise Ratio

PHONO

70 dB/66 dB

(’66 IHF/DIN)

CD, TAPE, VCR, VIDEO

87 dB/67 dB

RIAA Phono Equalization

 

±0.5 dB (20 Hz to 20 kHz)

Loudness

 

+5 ± 2 dB at 100 Hz

(Volume Control at –40 dB)

 

 

Video Input Sensitivity/

VCR, VIDEO

1 Vp-p/75 ohms

Impedance

 

 

Video Output Level

VCR, MONITOR OUT

1 Vp-p (at 1 Vp-p input)

Synchronization

 

negative

Signal-to-Noise Ratio

 

45 dB

Page 31

Image 36
Contents RX-430VBK Per I’ltalia English Deutsch Français Nederlands Español Italiano Voorzichtig -- Power en STANDBY/ON RX-430VBK Table of Contents Switches, Buttons and Controls Remote ControlFront Panel Before Installation Checking the Supplied AccessoriesGetting Started Connecting the FM and AM MW/LW Antennas Using the Supplied FM AntennaFM Antenna Connections AM MW/LW Antenna ConnectionsConnecting the Speakers Connecting the front speakersConnecting the rear and center speakers Case 1 When you connect only front speakers Case 2 When you connect front speakers and a center speakerCase 3 When you connect front and rear speakers About the speaker impedance of the speakersConnecting Audio/Video Components Connecting the subwoofer speakerAudio component connections Audio Components Video ComponentsVideo component connections VCRConnecting the Power Cord Putting Batteries in the Remote ControlPlug the power cord into an AC outlet Press Power to set it in the on positionTurning the Power On and Off Standby Basic OperationsSelecting the Source to Play Adjusting the Volume From the remote control onlySelecting the Front Speakers Muting the SoundListening with Headphones Recording a SourceBasic Settings Adjusting the Front Speaker Output BalanceListening at Low Volume Loudness Using the Sleep TimerSelecting the Center Speaker Size Large Small noLarge SmallUsing the One Touch Operation To store the sound settings Press ONE Touch OperationTo cancel the One Touch Operation function One Touch OperationTuning in Stations Manually Using Preset TuningStoring the preset stations Receiving Radio BroadcastsSelecting the FM Reception Mode Tuning in a Preset StationFM Auto FM MonoUsing the Preset SEA Modes Selecting Your Favorite SEA ModeMovie Sports Music SPORTS1 SPORTS2 SPORTS3Press Preset to select the effect level Movie SPORTS2 JazzMovie 1 Movie 2 Movie Using the Surround Processor Using JVC’s Hall SurroundWhat is surround? Prologic 3CHLOGIC HallDelay 1 Delay 2 Delay DelayPress Rear +/- to adjust the rear speaker output level Press Delay to adjust the delay timeSpeaker Arrangements for Dolby Surround This casePreparing for Dolby Surround Wide Normal PhantomIf necessary, adjust the speaker output balance as follows Left front Center Right front Speaker Rear speakersPress Test to start checking the speaker output balance Press Test again to stop the test toneUsing Dolby Surround LOGIC, Hall lights up on the displayCompu Link Remote Control System Remote Control through the Remote Sensor on the ReceiverAutomatic Source Selection Synchronized RecordingUsing the Remote Control SEA Surround Control ON/OFF Troubleshooting Problem Possible Cause SolutionSpecifications AmplifierFM tuner IHF AM MW/LW tunerGeneral EN, GE, FR, NL, SP, IT 0497OFYOTKJEM

RX-430VBK specifications

The JVC RX-430VBK is a versatile stereo receiver that has captured the attention of audio enthusiasts and casual listeners alike. Designed for those who appreciate quality sound in a compact format, this receiver comes packed with features that enhance its functionality and audio performance.

One of the main highlights of the RX-430VBK is its power output, delivering a robust 100 watts per channel. This power capacity ensures clear and dynamic sound reproduction, making it suitable for a wide range of listening environments. Whether you are enjoying music, watching movies, or gaming, the RX-430VBK provides an immersive audio experience that brings your media to life.

The receiver features a built-in AM/FM tuner, allowing users to easily access their favorite radio stations. The tuner is equipped with a preset channel memory, letting users store up to 30 stations for quick access. This feature is especially convenient for those who enjoy a mix of local and national broadcasts.

For connectivity, the JVC RX-430VBK is well-equipped with multiple inputs and outputs, including five audio inputs and a dedicated phono input for turntables. This makes it an ideal choice for vinyl enthusiasts who want to connect their record player without the need for additional preamps. Additionally, it includes a headphone jack for private listening, as well as speaker outputs that support either A or B configurations, allowing for flexible setups.

Another standout feature of the RX-430VBK is its built-in digital signal processing (DSP). This technology enables users to tailor their audio experience with various sound modes such as Hall, Jazz, and Rock, which enhance the listening experience depending on the genre. The built-in EQ further allows for fine-tuning the audio output, helping users achieve their desired sound profile.

From a design perspective, the RX-430VBK boasts a sleek and modern aesthetic that fits comfortably into most home entertainment setups. Its user-friendly interface and remote control make it easy to navigate settings and manage playback from a distance.

In summary, the JVC RX-430VBK is a powerful and feature-rich stereo receiver that caters to a broad range of audio preferences and setups. With its solid power output, versatile connectivity options, and innovative sound technologies, it stands out as a strong choice for anyone looking to enhance their audio experience at home.