Getting Started
This section explains how to connect audio/video components and speakers to the receiver, and how to connect the power supply.
English
Before Installation
General Precautions
•Be sure your hands are dry.
•Turn the power off to all components.
•Read the manuals supplied with the components you are going to connect.
Locations
•Install the receiver in a location that is level and protected from moisture and dust.
•The temperature around the receiver must be between
•Make sure there is good ventilation around the receiver. Poor ventilation could cause overheating and damage the receiver.
Notes:
•Supplied batteries are for the initial setup. Replace for continued use.
•For
CAUTION:
Follow these precautions to avoid leaking or cracking cells:
•Place batteries in the remote control so they match the polarity: (+) to (+) and
•Use the correct type of batteries. Batteries that look similar may differ in voltage.
•Always replace both batteries at the same time.
•Do not expose batteries to heat or flame.
Handling the receiver | Connecting the FM and AM Antennas |
| |
• Do not insert any metal object into the receiver. | FM antenna connections |
• Do not disassemble the receiver or remove screws, covers, or |
|
cabinet. |
|
• Do not expose the receiver to rain or moisture. |
|
Checking the Supplied Accessories
Check to be sure you have all of the following items, which are supplied with the receiver.
The number in the parentheses indicates quantity of the pieces supplied.
•Remote Control (1)
•Batteries (2)
•AM Loop Antenna (1)
•FM Antenna (1)
•AC Plug Adaptor (1)
If anything is missing, contact your dealer immediately.
Putting Batteries in the Remote Control
Before using the remote control, insert the two supplied batteries first.
1 | 2 | 3 | ||||
| AA(15F) |
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1Press and slide the battery cover on the back of the remote control.
2Insert the batteries.
• Make sure to match the polarity: (+) to (+) and
3Replace the cover.
If the remote control cannot transmit signals or operate the receiver correctly, replace the batteries. Use two
AB
AM | AM |
EXT | EXT |
AM | AM |
LOOP | LOOP |
75 | ANTENNA | 75 | ANTENNA |
|
| ||
COAXIAL |
| COAXIAL |
|
FM |
| FM |
|
Extend the supplied FM antenna horizontally.
AM
EXT
AM
LOOP
FM Antenna (supplied)
FM 75 |
|
|
COAXIAL |
| Outdoor FM Antenna Cable |
| ANTENNA | |
| (not supplied) | |
|
|
Connect the supplied FM antenna as temporary measure to the FM 75 Ω COAXIAL
If reception is poor, connect the outdoor FM antenna (not
1Disconnect the supplied FM antenna.
2Connect a 75 Ω coaxial cable with the standard type connector
(IEC or DIN45325).
5