JVC RX-8012VSL manual USB Connection, Lamp on the USB Audio button lights up, USB cable

English

USB Connection

This receiver is equipped with a USB terminal on the front panel. You can connect your PC to this terminal and enjoy sound reproduced through your PC.

When you connect your PC for the first time, follow the procedure below.

•Remember you cannot send any signal or data to your PC from this receiver.

IMPORTANT

•Check if your PC equipped with the CD-ROM drive is running on WindowsR 98*, WindowsR Me*, or WindowsR 2000* and prepare its CD-ROM.

•Check your PC’s BIOS setting — whether USB is available, and whether USB IRQ is set to “AUTO” or to available IRQ number.

How to install the USB drivers

The following procedure is described using the English version of WindowsR 98. If your PC is running on a different version of Windows, the screens shown on your PC’s monitor will differ from the ones used in the following procedure.

1.Turn on your PC and start running WindowsR 98, WindowsR Me or WindowsR 2000.

If the PC has been turned on, quit all the applications now running.

2.Turn on the receiver, and press USB AUDIO on the front panel or USB on the remote control.

The lamp on the USB AUDIO button lights up.

3.Connect the receiver to the PC using a USB cable (not supplied).

Your PC automatically recognizes this connection, and shows the following screen on the monitor.

USB AUDIO			VIDEO
	S-VIDEO	VIDEO		L—AUDIO—R

PC

USB cable

4.Install the USB drivers following the instructions on the PC’s monitor.

5.Check if the drivers are correctly installed.

1.Open the Control Panel on your PC: Select [Start] = [Settings] = [Control Panel]

2.Select [System], then [Device Manager] and click [Sound, video and game controllers] and [Universal Serial Bus controllers.]

The following window appears, and you can check whether the drivers are installed.

Note:

The items shown on the PC’s monitor differ depending on your PC settings.

6.Change the PC audio setting.

1.If you have closed Control Panel, open it again: Select [Start] =[Settings] =[Control Panel]

2.Click [Multimedia], then select “USB Audio Device [1]” for “Playback” of “Audio,” and close the window.

To play back a CD from CD-ROM drive on PC, click [Multimedia], [CD Music] then check [Enable digital CD audio for this CD-ROM device].

Now PC is ready for playback through the USB connection.

After installation is completed, you can use your PC as the playback source. The PC automatically recognizes the receiver whenever a USB cable is connected between the PC and the receiver while the receiver is turned on.

•When not using the PC as the playback source, disconnect the USB cable.

To play back sounds on the PC, refer to the manuals supplied with the sound reproduction application installed in the PC.

Notes:

•DO NOT turn off the receiver or disconnect the USB cable while installing the drivers and for a several seconds each time your PC is recognizing the receiver.

•Use a full speed USB cable (revision 1.0).

•If your PC does not recognize the receiver, disconnect the USB cable and connect it again. If this does not work, restart Windows.

•The drivers installed can be recognized only when the USB cable is connected between the receiver and your PC.

•The sound may not be played back correctly — interrupted or degraded — due to your PC settings and PC specifications.

*Microsoft R, WindowsR 98, WindowsR Me and WindowsR 2000 are registered trademarks of Microsoft Corporation.

9