JVC RX-668RBK Connecting the Speakers, AM MW/LW Antenna Connections, Basic connecting procedure

Page 7

AM (MW/LW) Antenna Connections

Snap the tabs on the loop into the

ANTENNA

slots of the base to assemble the

FM 75

AM (MW/LW) loop.

COAXIAL

 

Basic connecting procedure

1

2

3

 

 

 

English

AM

LOOP

AM

EXT AM (MW/LW) Loop Antenna

123

Outdoor single vinyl-covered wire

Turn the loop until you have the best reception.

Notes:

•Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.

•If reception is poor, connect an outdoor single vinyl-covered wire to the AM EXT terminal. (Keep the AM (MW/LW) loop antenna connected.)

Connecting the Speakers

You can connect the following speakers:

•Two pairs of front speakers to produce normal stereo sound.

•One pair of rear speakers to enjoy the surround effect.

•One center speaker to produce more effective surround effect (to emphasize human voices).

•One subwoofer to enhance the bass.

IMPORTANT:

After connecting the speakers listed above, set the speaker setting information properly to obtain the best possible surround effect. For details, see page 11.

For each speaker (except for a subwoofer), connect the (–) and (+) terminals on the rear panel to the (–) and (+) terminals marked on the speakers. For connecting a subwoofer, see page 5.

CAUTION:

Use speakers with the SPEAKER IMPEDANCE indicated by the

speaker terminals.

1Cut, twist and remove the insulation at the end of each speaker signal cable.

2Open the terminal and then insert the speaker signal cable.

3Close the terminal.

Connecting the front speakers

You can connect two pairs of front speakers (one pair to the FRONT SPEAKERS 1 terminals, and another pair to the FRONT SPEAKERS 2 terminals).

Right speaker

 

FRONT SPEAKERS 1

 

Left speaker

 

 

FRONT SPEAKERS

RIGHTLEFT

1

1

2

2

Right speaker

 

FRONT SPEAKERS 2

 

Left speaker

 

 

Connecting the rear and center speakers

Connect rear speakers to the REAR SPEAKERS terminals and a center speaker to the CENTER SPEAKER terminals.

Center speaker

CENTER

RIGHT

LEFT

SPEAKER

 

 

 

 

 

 

Left rear

Right rear

 

 

REAR

speaker

speaker

 

 

 

 

SPEAKERS

4

Page 6 Page 8
Image 7
Page 6 Page 8
Contents RX-668RBK Per I’ltalia Español Italiano Table of Contents To use the Cursor control buttons w on the front panel Remote ControlParts Identification Front PanelGetting Started Before InstallationConnecting the FM and AM MW/LW Antennas Checking the Supplied AccessoriesConnecting the rear and center speakers Connecting the SpeakersBasic connecting procedure Connecting the front speakersConnecting the subwoofer speaker Connecting Audio/Video ComponentsAudio component connections Input Video component connectionsTV or Monitor DVD playerReplace the cover Connecting the Power CordPutting Batteries in the Remote Control Plug the power cord into an AC outletOn the front panel Turning the Power On and Off StandbyFrom the remote control Basic OperationsMuting the Sound Selecting the Front SpeakersRecording a Source Reinforcing the Bass Attenuating the Input SignalAdjusting the Front Speaker Output Balance Adjusting the ToneChanging the Source Name Basic SettingsSetting Center and Rear Speakers for DSP Modes Press Setting so that the cursorAdjust the sound using the functions listed above Using the Sleep TimerPress ONE Touch Operation Using Preset Tuning Tuning in Stations ManuallyReceiving Radio Broadcasts When an FM stereo broadcast is hard to receive or noisy Using the RDS Radio Data System to Receive FM StationsWhat Information Can RDS Signals Provide? Listening to an FM station To search for a program using the PTY codesSearching for a Program by PTY Codes Press PTY Search whilePress TA/NEWS/INFO until Switching to a Broadcast Program of Your Choice TemporarilyProgram type you want appears on Display Dolby Surround Using the DSP Modes3D-PHONIC modes Surround ModesRear Speaker Available DSP Modes According to the Speaker ArrangementFront RearAdjusting DAP Modes Adjusting the 3D-PHONIC ModesRear speaker output level from 10 to +10 Press Rearl / + to adjust the rear speaker output levelUntil the mode PRO Logic Or Theater appears on Display Output balanceSelect and play a sound source Press Surround repeatedly Until the DSP mode you wantTo cancel the DSP mode Activating the DSP ModesActivating the DVD Multi Playback Mode Using the DVD Multi Playback ModeUsing the On-Screen Menus On or OFF To Bass BoostPress @/ #to turn Bass Boost functionPress %/ Þto move to Tone CONTROL, then press @/ # Press %/ Þ/ @/ #to adjust the tone as you wantPress %/ Þto move to SETTING, then press @/ # Press % / Þto move to Surround LEVEL, then press @/ #Press %/ Þto move to RDS INFORMATION, then press @/ # Press %/ Þto move to Preset MEMORY, then press @/ #Storing the Preset Stations Also see Press %/ Þto move To Tuner CONTROL, then Press @/ #Automatic Source Selection Compu Link Remote Control SystemRemote Control through the Remote Sensor on the Receiver Same timeDisc Search Only for CD Player Text Compu Link Remote Control SystemCD player MD recorder Displaying the Disc Information on the TV screenPress on Screen Exit again Press Text Display while CD or MD is selected as the sourceShowing the Disc Information on the TV Screen To exit from the Disc information screenPress on Screen SET again Press Text Display while CD is selected as the sourcePress %/ Þto move to SEARCH, then Press on Screen SET Press %/ Þto move to PERFORMER, then press onEntering the Disc Information Press %/ Þto move To Search Then press onPress %/ Þto move To GENRE, then Press on Screen Then press on Screen SETFor the MD recorder Up to 32 characters to this User FileEnter the disc title, referring to steps 3 Press Text Display while MD is selected as the sourceCD player Operating JVC’s Audio/Video ComponentsTuner Sound control section AmplifierMD recorder Cassette deckDVD player Problem Possible Cause Solution TroubleshootingAM MW/LW tuner SpecificationsAmplifier FM tuner IHFEN, GE, FR, NL, SP, IT 0299JTMMDWJEM

RX-668RBK specifications

The JVC RX-668RBK is a commendable addition to the world of home audio receivers, delivering a blend of impressive features and robust sound performance ideal for both casual listeners and audiophiles alike. This 5.1-channel AV receiver stands as a testament to JVC's commitment to quality and innovation in home entertainment systems.

One of the standout features of the RX-668RBK is its power output. Capable of delivering up to 100 watts per channel, the receiver ensures that users can enjoy clear, dynamic sound at any volume level. The receiver supports a range of audio formats, including Dolby Digital and DTS, which provide an immersive experience during movie nights or while enjoying music. This multi-channel setup allows for true surround sound, transporting listeners straight into the action.

The RX-668RBK is equipped with a sophisticated digital signal processing technology that enhances audio quality across different types of content. The built-in equalizer function offers users the flexibility to customize their sound preferences, allowing for adjustments based on the specifics of the room and the type of media being played. Whether you are watching a fast-paced action film or listening to your favorite album, the receiver adapts seamlessly to deliver optimal sound performance.

Connectivity options are plentiful, as the RX-668RBK features multiple HDMI inputs, enabling users to connect a variety of sources, such as Blu-ray players, gaming consoles, and streaming devices. The receiver also includes optical and coaxial digital inputs, as well as analog audio inputs, ensuring compatibility with both modern and legacy devices. Additionally, the front USB input allows for easy connectivity to USB sources, making it simple to play digital music files.

The user interface of the JVC RX-668RBK is designed for convenience, featuring an intuitive on-screen display that simplifies setup and navigation. The remote control enhances this ease of use, allowing users to manage their audio settings and select input sources from the comfort of their couch.

Overall, the JVC RX-668RBK stands out for its robust feature set, superior sound processing technologies, and versatile connectivity options. It is a reliable choice for anyone looking to enhance their home audio experience, creating a perfect blend of convenience, quality, and exceptional performance.
Top Page Image Contents