JVC RX-630RBK manual Press Test to start checking the speaker output balance

Page 38

English

ON/OFF

MODE

DELAY

TEST

REAR

CENTER

TEST

Remote Control

From the remote control:

Note:

You cannot adjust the center mode and the center tone using the remote control.

1.Press ON/OFF so that the SURROUND indicator lights up on the display.

The previous surround mode is recalled (at its previous settings) and is shown on the display. Each time you press the button, the surround mode turns on and off.

2.Press MODE until “PROLOGIC” or “3CHLOGIC” whichever you want appears on the display.

Each time you press the button, the surround modes change as follows (the indicator of the selected surround mode also lights up on the display):

PROLOGIC 3CHLOGIC HALL

SURR OFF

(Surround Off)

3.Press DELAY to adjust the delay time of the rear speaker output. Each time you press the button, the delay time changes as follows:

DELAY 1 DELAY 2

DELAY 4 DELAY 3

Note:

When you have selected “3CHLOGIC,” you cannot adjust the delay time.

4.Press TEST to start checking the speaker output balance.

“TEST” starts flashing on the display, and a test tone comes out of the speakers in the following order:

Left front speakerCenter speaker Right front speaker Rear speakers

Notes:

No test tone comes out of the rear speakers when you have selected “3CHLOGIC.”

No test tone comes out of the center speaker when you select “PHANTOM” or “OFF” for the center mode.

5.If necessary, adjust the speaker output level as follows:

To adjust the rear speaker output level, press REAR +/–.

To adjust the center speaker output level, press CENTER +/–.

Pressing – decreases the output level up to –10 dB.

Pressing + increases the output level up to +10 dB.

Notes:

You cannot adjust the left and right rear speaker output level separately.

You cannot adjust the rear speaker output level when you have selected “3CHLOGIC.”

You cannot adjust the center speaker output level when you select “PHANTOM” or “OFF” for the center mode.

6.Press TEST again to stop the test tone.

Page 33

Image 38
Contents RX-630RBK Per I’ltalia English Deutsch Français Nederlands Español Italiano Voorzichtig -- Power en STANDBY/ON RX-630RBK Table of Contents Getting Started Before InstallationChecking the Supplied Accessories Front Panel Switches, Buttons and ControlsFront Panel Remote Control Remote ControlUsing the Standard Type Connector Not Supplied Connecting the FM and AM MW/LW AntennasUsing the Supplied FM Antenna FM Antenna ConnectionsConnecting the Speakers Connecting the front speakersOpen the terminal Connecting the rear and center speakersConnecting the subwoofer speaker Close the terminalCase 2 When you connect front speakers and a center speaker Case 1 When you connect only front speakersCase 3 When you connect front and rear speakers About the speaker impedance of the speakersAudio Components Video Components Connecting Audio/Video ComponentsAudio component connections If your audio components have a Compu LINK-3 terminalPress Power to set it in the on position Connecting the Power CordPlug the power cord into an AC outlet To shut off the power completelyPutting Batteries in the Remote Control R6PSUM-3/AA 15FSelecting the Source to Play Turning the Power On and OffBasic Operations On the front panel only Adjusting the VolumeSelecting the Front Speakers Recording a Source Listening with HeadphonesMuting the Sound Listening at Low Volume Loudness Basic SettingsAdjusting the Front Speaker Output Balance FunctionTo cancel the Sleep Timer Using the Sleep TimerWhen the shut-off time comes From the remote control Press Sleep repeatedlyLarge Selecting the Center Speaker SizeLarge Small SmallAbout the One Touch Operation Using the One Touch OperationOne Touch Operation Storing the preset stations Tuning in Stations ManuallyUsing Preset Tuning Receiving Radio BroadcastsAuto Selecting the FM Reception ModeTuning in a preset station MonoPress Control % / Þto select a character Assigning Names to Preset StationsWhen a character you want appears, press Control #or @ Available charactersPTY Using the RDS Radio Data System to Receive FM StationsWhat Information Can RDS Signals Provide? Searching for a Program by PTY Codes Affairs AlarmNews InfoCase Switching to a Broadcast Program of Your Choice TemporarilyTA NEWS/INFO TA/INFO TA/NEWS News Info TA/NEWS/INFO Rock Musical Movie Country SEA OFF Usermode Jazz Using the SEA ModesSelecting Your Favorite SEA Mode To recall your own SEA adjustment Creating Your Own SEA ModeAdjust the SEA frequency and its level To erase a stored adjustmentWhat is surround? Using the Surround ProcessorUsing JVC’s Hall Surround Prologic 3CHLOGIC Hall Surr OFFPress Mode repeatedly until Hall appears on the display Delay 1 Delay Delay 4 DelayDelay Press Rear +/- to adjust the rear speaker output levelSpeaker Arrangements for Dolby Surround When you have added rear speakers without a center speakerWhen you have added a center speaker without rear speakers Preparing for Dolby Surround Wide Normal PhantomSOFT2 SOFT1 Flat SHARP1 SHARP2 DelayIf necessary, adjust the speaker output level as follows Press Test to start checking the speaker output balance Press Test again to stop the test toneUsing Dolby Surround Automatic Source Selection Compu Link Remote Control SystemRemote Control through the Remote Sensor on the Receiver Synchronized RecordingTo operate JVC’s audio components using this remote control Enter button after selecting a channel number Troubleshooting Problem Possible Cause SolutionVideo SpecificationsAmplifier General FM tuner IHFAM MW/LW tuner EN, GE, FR, NL, SP, IT 0697OFYOTKJEM

RX-630RBK specifications

The JVC RX-630RBK is a versatile and powerful stereo receiver designed to enhance your home audio experience. With a sleek and modern design, it fits seamlessly into any entertainment setup while providing robust sound quality and an array of features.

One of the main highlights of the RX-630RBK is its solid power output, delivering 100 watts per channel across a wide frequency range. This ensures that whether you're listening to music, watching movies, or playing video games, the audio experience is both rich and immersive. The receiver also supports both stereo and multi-channel formats, making it an excellent choice for various audio sources.

The RX-630RBK incorporates advanced technologies to optimize sound performance. It features a built-in FM/AM tuner with 30 preset stations, allowing you to easily access your favorite radio channels. The receiver also has a dedicated phono input, enabling audiophiles to connect their turntables and enjoy vinyl records with clarity and depth. Additionally, it supports digital audio inputs, including optical and coaxial connections, ensuring compatibility with modern devices.

User-friendly controls and a remote make it easy to navigate through various settings and audio sources. The LCD display provides clear information about current settings, making adjustments straightforward. The receiver is equipped with multiple audio inputs, including auxiliary and USB ports, allowing you to connect smartphones, tablets, or other audio sources effortlessly.

Another notable feature of the JVC RX-630RBK is its adjustable equalizer settings. This allows users to fine-tune the audio output to suit their preferences or the acoustics of their room. Bass and treble adjustments ensure that you can enjoy music and other audio content exactly as you like it.

The RX-630RBK also prioritizes safety, featuring built-in protection circuits to prevent overheating and overload, ensuring longevity and reliability.

In summary, the JVC RX-630RBK is a powerful and feature-rich stereo receiver offering exceptional sound quality and versatile connectivity options. Its combination of advanced technology, user-friendly controls, and thoughtful features make it an ideal choice for audio enthusiasts looking to elevate their listening experience at home. With the RX-630RBK, enjoying high-fidelity sound has never been easier or more accessible.