JVC RX-630RBK manual FM tuner IHF, AM MW/LW tuner, General

Page 45

FM tuner (IHF)

Tuning Range

 

87.5 MHz to 108.0 MHz

Usable Sensitivity

Monaural

10.8 dBf (0.95 µV/75 ohms)

50 dB Quieting Sensitivity

Monaural

16.3 dBf (1.8 µV/75 ohms)

 

Stereo

38.3 dBf (22.5 µV/75 ohms)

Signal-to-Noise Ratio

Monaural

80 dB at 85 dBf

(IHF-A weighted)

Stereo

73 dB at 85 dBf

Total Harmonic Distortion

Monaural

0.15 % at 1 kHz

 

Stereo

0.2 % at 1 kHz

Stereo Separation at REC OUT

 

40 dB at 1 kHz

Capture Ratio

 

1.5 dB (10 mV)

Alternate Channel Selectivity

 

60 dB: (±400 kHz)

Frequency Response

 

30 Hz to 15 kHz: (+0.5 dB, –3 dB)

AM (MW/LW) tuner

Tuning Range

MW:

522 kHz to 1,629 kHz

 

LW:

144 kHz to 288 kHz

Usable Sensitivity

MW: Loop antenna

300 µV/m

 

External antenna

30 µV

 

LW: Loop antenna

600 µV/m

Signal-to-Noise Ratio

 

50 dB (100 mV/m)

General

Power Requirements

AC 230V

, 50 Hz

Power Consumption

280 watts

 

 

2 watts (in standby mode)

Dimensions (W x H x D)

435 x 156.5 x 412 mm

 

(17 3/16 x 6 3/16 x 16 1/4 inches)

Mass

10.3 kg (22.7 lbs)

 

Designs & specifications are subject to change without notice.

English

Page 40

Image 45
Contents RX-630RBK Per I’ltalia English Deutsch Français Nederlands Español Italiano Voorzichtig -- Power en STANDBY/ON RX-630RBK Table of Contents Before Installation Checking the Supplied AccessoriesGetting Started Switches, Buttons and Controls Front PanelFront Panel Remote Control Remote ControlUsing the Supplied FM Antenna Connecting the FM and AM MW/LW AntennasUsing the Standard Type Connector Not Supplied FM Antenna ConnectionsConnecting the front speakers Connecting the SpeakersConnecting the subwoofer speaker Connecting the rear and center speakersOpen the terminal Close the terminalCase 3 When you connect front and rear speakers Case 1 When you connect only front speakersCase 2 When you connect front speakers and a center speaker About the speaker impedance of the speakersAudio component connections Connecting Audio/Video ComponentsAudio Components Video Components If your audio components have a Compu LINK-3 terminalPlug the power cord into an AC outlet Connecting the Power CordPress Power to set it in the on position To shut off the power completelyR6PSUM-3/AA 15F Putting Batteries in the Remote ControlTurning the Power On and Off Basic OperationsSelecting the Source to Play Adjusting the Volume Selecting the Front SpeakersOn the front panel only Listening with Headphones Muting the SoundRecording a Source Adjusting the Front Speaker Output Balance Basic SettingsListening at Low Volume Loudness FunctionWhen the shut-off time comes Using the Sleep TimerTo cancel the Sleep Timer From the remote control Press Sleep repeatedlyLarge Small Selecting the Center Speaker SizeLarge SmallUsing the One Touch Operation One Touch OperationAbout the One Touch Operation Using Preset Tuning Tuning in Stations ManuallyStoring the preset stations Receiving Radio BroadcastsTuning in a preset station Selecting the FM Reception ModeAuto MonoWhen a character you want appears, press Control #or @ Assigning Names to Preset StationsPress Control % / Þto select a character Available charactersUsing the RDS Radio Data System to Receive FM Stations What Information Can RDS Signals Provide?PTY Searching for a Program by PTY Codes News AlarmAffairs InfoSwitching to a Broadcast Program of Your Choice Temporarily TA NEWS/INFO TA/INFO TA/NEWS News Info TA/NEWS/INFOCase Using the SEA Modes Selecting Your Favorite SEA ModeRock Musical Movie Country SEA OFF Usermode Jazz Adjust the SEA frequency and its level Creating Your Own SEA ModeTo recall your own SEA adjustment To erase a stored adjustmentUsing JVC’s Hall Surround Using the Surround ProcessorWhat is surround? Prologic 3CHLOGIC Hall Surr OFFDelay Delay 1 Delay Delay 4 DelayPress Mode repeatedly until Hall appears on the display Press Rear +/- to adjust the rear speaker output levelWhen you have added rear speakers without a center speaker When you have added a center speaker without rear speakersSpeaker Arrangements for Dolby Surround Wide Normal Phantom Preparing for Dolby SurroundDelay If necessary, adjust the speaker output level as followsSOFT2 SOFT1 Flat SHARP1 SHARP2 Press Test again to stop the test tone Press Test to start checking the speaker output balanceUsing Dolby Surround Remote Control through the Remote Sensor on the Receiver Compu Link Remote Control SystemAutomatic Source Selection Synchronized RecordingTo operate JVC’s audio components using this remote control Enter button after selecting a channel number Problem Possible Cause Solution TroubleshootingSpecifications AmplifierVideo FM tuner IHF AM MW/LW tunerGeneral EN, GE, FR, NL, SP, IT 0697OFYOTKJEM

RX-630RBK specifications

The JVC RX-630RBK is a versatile and powerful stereo receiver designed to enhance your home audio experience. With a sleek and modern design, it fits seamlessly into any entertainment setup while providing robust sound quality and an array of features.

One of the main highlights of the RX-630RBK is its solid power output, delivering 100 watts per channel across a wide frequency range. This ensures that whether you're listening to music, watching movies, or playing video games, the audio experience is both rich and immersive. The receiver also supports both stereo and multi-channel formats, making it an excellent choice for various audio sources.

The RX-630RBK incorporates advanced technologies to optimize sound performance. It features a built-in FM/AM tuner with 30 preset stations, allowing you to easily access your favorite radio channels. The receiver also has a dedicated phono input, enabling audiophiles to connect their turntables and enjoy vinyl records with clarity and depth. Additionally, it supports digital audio inputs, including optical and coaxial connections, ensuring compatibility with modern devices.

User-friendly controls and a remote make it easy to navigate through various settings and audio sources. The LCD display provides clear information about current settings, making adjustments straightforward. The receiver is equipped with multiple audio inputs, including auxiliary and USB ports, allowing you to connect smartphones, tablets, or other audio sources effortlessly.

Another notable feature of the JVC RX-630RBK is its adjustable equalizer settings. This allows users to fine-tune the audio output to suit their preferences or the acoustics of their room. Bass and treble adjustments ensure that you can enjoy music and other audio content exactly as you like it.

The RX-630RBK also prioritizes safety, featuring built-in protection circuits to prevent overheating and overload, ensuring longevity and reliability.

In summary, the JVC RX-630RBK is a powerful and feature-rich stereo receiver offering exceptional sound quality and versatile connectivity options. Its combination of advanced technology, user-friendly controls, and thoughtful features make it an ideal choice for audio enthusiasts looking to elevate their listening experience at home. With the RX-630RBK, enjoying high-fidelity sound has never been easier or more accessible.