JVC RX-665VBK manual Getting Started, Connecting the front speakers, Connecting the Speakers

Page 12

Getting Started

English

Connecting the Speakers

You can connect the following speakers:

•Two sets of front speakers to produce normal stereo sound

•One set of rear speakers to enjoy the surround effect

•One center speaker to produce more effective surround effect (to make human voices outstanding)

•One subwoofer to enhance the bass

For each speaker (except for subwoofer), connect one end of the speaker signal cable (not supplied) to the speaker terminal on the rear panel and the other end to the speaker. (For connecting a subwoofer, see page 10.)

1. Open each terminal.

2. Insert the end of the speaker signal cable as shown (be sure to remove the insulation at the end of each wire first).

3. Close the terminals to clamp the speaker signal cables firmly in place.

4. Connect the (–) and (+) terminals on the rear panel to the (–) and (+) terminals marked on the speakers.

Connecting the front speakers

Connect the front speakers to the FRONT SPEAKERS terminals.

SPEAKERS 1

FRONT SPEAKERS

 

 

RIGHT

LEFT

 

1

1

Left speaker

Right speaker

2

 

2

SPEAKERS 2

 

CAUTION:

When connecting speakers, use speakers with the SAME IMPEDANCE indicated by the speaker terminals.

9

Page 11 Page 13
Image 12
Page 11 Page 13
Contents RX-665VBK Mises en garde, précautions et indications diverses For actual setting procedures, see pages 26 to Niveau d’effetTable of Contents Remote Control $ Power buttons CATV/SAT, TV, VCR Audio 14, 45, 46Parts Identification Front PanelEasy Set Up & Operations For Reproducing Surround Sound with your VCRTurn on the power Easy Set Up & Operations For Reproducing DVD Multi Playback with your DVD playerMake further Getting Started GeneralLocations Handling the receiverConnecting the FM and AM Antennas FM Antenna ConnectionsAM Antenna Connections Connecting the front speakers Connecting the SpeakersGetting Started Connect the front speakers to the Front Speakers terminalsConnecting the rear and center speakers Connecting the subwooferConnecting Audio/Video Components Audio component connectionsVideo component connections If your audio components have a Compu LINK-3 terminalDVD player connection If your audio components have an AV Compu Link terminalConnecting the Power Cord Putting Batteries in the Remote ControlFrom the remote control Turning the Power On and OffBasic Operations On the front panelFrom the remote control only Basic OperationsOn the front panel only Listening with Headphones To listen with only headphonesRecording a Source Basic Settings Adjusting the Front Speaker Output BalanceListening at Low Volume Loudness Using the Sleep TimerWhen the shut-off time comes To cancel the Sleep TimerReceiver turns off automatically Basic Settings Selecting the Center Speaker SizeSmall LargeTo store the sound settings To recall the sound settingsTo cancel the One Touch Operation function One Touch OperationTuning in Stations Manually Using Preset TuningTo store the preset stations Receiving Radio BroadcastsTo cancel a stored preset station To tune in a preset stationPress 10 keys to select a preset channel number Selecting the FM Reception Mode Receiving Radio BroadcastsUsing the Preset SEA Modes Selecting Your Favorite SEA ModeTo cancel the preset SEA mode Using the Preset SEA Modes Press SEA Preset to select the effect levelUsing the Surround Processor On JVC 3D-PHONIC modeOn the DAP mode On surround modesUsing the Surround Processor Using JVC 3D-PHONIC Modes3DACTION 3DTHEATRPress Control 2/ 3to adjust the effect level To cancel the 3D-PHONIC modeMark Press Effect to select the effect levelUsing the DAP Modes PavilionHall To cancel the DAP mode Select OFF in step DAP indicator goes off from the displayPress Rear L +/- to adjust the rear speaker Output level Effect Select Prologic or Theater Select Phantom for center mode Select 3CHLOGIC Select Normal or Wide for center modeSpeaker Arrangements for Surround Modes This casePreparing for Surround Modes Press Surround so that the ControlPrologic TheaterPress Control 2/ 3to select the center mode DelayWide NormalIf necessary, adjust the speaker output balance as follows Delay 1 Delay 2 DelayPress Effect to adjust the effect level Press Test to start checking the speaker output balancePress Test again to stop the test tone Using Surround Modes To cancel Surround modePrevious mode is recalled with its previous From the front panelUsing the DVD Multi Playback Mode Speaker arrangements for DVD Multi playbackActivating the DVD Multi playback Using the DVD Multi Playback Mode Compu Link Remote Control System Remote Control through the Remote Sensor on the ReceiverAutomatic Source Selection Synchronized RecordingAV Compu Link Remote Control System Connect to the terminal indicated IllustrationDo not connect to the TV terminal Automatic Selection of TV’s Input Mode Automatic Power On/OffSee page 44 for details One-Touch Video PlayTo operate JVC audio components using this remote control Operating Other ComponentsStarts playing Starts playbackTo operate JVC video components using this remote control After pressing VCR, you can performFollowing operations on the VCR TV Volume + TV/VIDEOReturn Press and hold CATV/SAT in the Power section Enter manufacturer’s code two digits usingRelease CATV/SAT in the Power section CATV/SAT in the PowerPress and hold VCR in the Power section Release VCR in the Power sectionTry to operate your VCR by pressing VCR Power Operating Other Manufacturers’ Video EquipmentTroubleshooting Problem Possible Cause SolutionSpecifications AmplifierFM tuner IHF AM tunerGeneral EN, FR

RX-665VBK specifications

The JVC RX-665VBK is a versatile and feature-rich audio receiver that has earned recognition for its balanced performance and modern connectivity options. Designed for home theater enthusiasts and music lovers alike, this receiver delivers a powerful audio experience while seamlessly integrating into your existing entertainment setup.

One of the standout features of the RX-665VBK is its robust amplification system. With a total output power of 100 watts per channel, it provides ample power to drive a wide range of speakers, making it suitable for various room sizes. The receiver employs direct energy technology, which enhances efficiency and minimizes distortion, resulting in clear and dynamic sound reproduction across all frequencies.

Connectivity is a strong point for the RX-665VBK, as it comes equipped with multiple HDMI inputs. This allows users to connect various devices such as Blu-ray players, gaming consoles, and streaming devices, all while supporting high-definition video formats. Additionally, the receiver features a dedicated HDMI out for easy connection to your television, ensuring that you can enjoy high-quality audio-visual content without complicating your setup.

Incorporating advanced digital processing technologies, the RX-665VBK supports Dolby Digital and DTS surround sound formats. This enables users to experience immersive audio that complements high-definition video, making it perfect for movie nights and gaming sessions. The receiver also includes a built-in AM/FM tuner, allowing you to listen to your favorite radio stations with ease.

User convenience is further enhanced by the inclusion of an intuitive on-screen display. This feature simplifies the setup process, guiding users through the configuration of speaker settings and audio adjustments. For added flexibility, the RX-665VBK supports multiple audio input options, including USB and auxiliary inputs, enabling seamless playback from various sources.

The JVC RX-665VBK is not just about audio performance; its sleek and modern design ensures it fits well in any living space. With a user-friendly remote control, managing your audio experience is simple and straightforward.

In conclusion, the JVC RX-665VBK stands as a commendable choice for anyone seeking an affordable yet powerful audio receiver. With its combination of impressive amplification, advanced technologies, and modern connectivity options, it caters to the diverse needs of home entertainment enthusiasts, making it a valuable addition to any audio setup.
Top Page Image Contents