JVC RX-665VBK FM Antenna Connections, AM Antenna Connections, Connecting the FM and AM Antennas

Page 11

Connecting the FM and AM Antennas

FM Antenna Connections

123

FM Antenna

 

ANTENNA

Extend the FM antenna horizontally.

 

 

 

 

FM

 

4

Outside FM Antenna Cable

75

 

 

 

 

GND

FM

 

 

 

 

 

 

 

GND

 

1

2

3 7/16 in.

 

AM

 

 

 

AM

LOOP

 

 

 

 

13/16 in.

 

 

EXT

 

 

 

(10 mm)

 

 

 

 

 

 

(20 mm)

 

 

English

Note:

If reception is poor, connect the outside antenna.

Before attaching a 75 Ω coaxial cable (the kind with a round wire going to an outside antenna), disconnect the supplied FM wire antenna.

How to strip the 75 Ω coaxial cable and connect it to the FM terminals

1.Strip back the outside covering of the 75 Ω coaxial cable to expose the braided metallic mesh about 13/16 inches (20 mm).

2.Pull the mesh back and twist it into a single connector as shown in the illustration above.

3.Strip the insulation about 7/16 inches (10 mm) back from the central wire.

4.Insert the twisted mesh and the central wire to the FM terminals, as shown in the illustration above.

AM Antenna Connections

ANTENNA

Turn the loop until you have

 

 

the best reception.

FM 75

GND

GND

AM

EXT

FM

AM Loop Antenna

AM

LOOP

Snap the tabs on the loop into the slots of the base to assemble the AM loop.

Notes :

• Make sure the antenna

conductors do not touch any

other terminals, connecting

cords and power cord. This

could cause poor reception.

• If reception is poor, connect an

outdoor single vinyl-covered

wire to the AM EXT terminal.

1 2 3

Outdoor Single Vinyl- covered Wire

(Keep the AM loop antenna

connected.)

8

Page 10 Page 12
Image 11
Page 10 Page 12
Contents RX-665VBK Mises en garde, précautions et indications diverses Niveau d’effet For actual setting procedures, see pages 26 toTable of Contents Front Panel Remote Control$ Power buttons CATV/SAT, TV, VCR Audio 14, 45, 46 Parts IdentificationFor Reproducing Surround Sound with your VCR Easy Set Up & OperationsTurn on the power For Reproducing DVD Multi Playback with your DVD player Easy Set Up & OperationsMake further Handling the receiver Getting StartedGeneral LocationsAM Antenna Connections Connecting the FM and AM AntennasFM Antenna Connections Connect the front speakers to the Front Speakers terminals Connecting the front speakersConnecting the Speakers Getting StartedConnecting the subwoofer Connecting the rear and center speakersIf your audio components have a Compu LINK-3 terminal Connecting Audio/Video ComponentsAudio component connections Video component connectionsIf your audio components have an AV Compu Link terminal DVD player connectionPutting Batteries in the Remote Control Connecting the Power CordOn the front panel From the remote controlTurning the Power On and Off Basic OperationsOn the front panel only From the remote control onlyBasic Operations Recording a Source Listening with HeadphonesTo listen with only headphones Using the Sleep Timer Basic SettingsAdjusting the Front Speaker Output Balance Listening at Low Volume LoudnessReceiver turns off automatically When the shut-off time comesTo cancel the Sleep Timer Large Basic SettingsSelecting the Center Speaker Size SmallOne Touch Operation To store the sound settingsTo recall the sound settings To cancel the One Touch Operation functionReceiving Radio Broadcasts Tuning in Stations ManuallyUsing Preset Tuning To store the preset stationsPress 10 keys to select a preset channel number To cancel a stored preset stationTo tune in a preset station Receiving Radio Broadcasts Selecting the FM Reception ModeTo cancel the preset SEA mode Using the Preset SEA ModesSelecting Your Favorite SEA Mode Press SEA Preset to select the effect level Using the Preset SEA ModesOn surround modes Using the Surround ProcessorOn JVC 3D-PHONIC mode On the DAP mode3DTHEATR Using the Surround ProcessorUsing JVC 3D-PHONIC Modes 3DACTIONPress Effect to select the effect level Press Control 2/ 3to adjust the effect levelTo cancel the 3D-PHONIC mode MarkHall Using the DAP ModesPavilion Press Rear L +/- to adjust the rear speaker Output level To cancel the DAP modeSelect OFF in step DAP indicator goes off from the display Effect This case Select Prologic or Theater Select Phantom for center modeSelect 3CHLOGIC Select Normal or Wide for center mode Speaker Arrangements for Surround ModesTheater Preparing for Surround ModesPress Surround so that the Control PrologicNormal Press Control 2/ 3to select the center modeDelay WideDelay 1 Delay 2 Delay If necessary, adjust the speaker output balance as followsPress Test again to stop the test tone Press Effect to adjust the effect levelPress Test to start checking the speaker output balance From the front panel Using Surround ModesTo cancel Surround mode Previous mode is recalled with its previousActivating the DVD Multi playback Using the DVD Multi Playback ModeSpeaker arrangements for DVD Multi playback Using the DVD Multi Playback Mode Synchronized Recording Compu Link Remote Control SystemRemote Control through the Remote Sensor on the Receiver Automatic Source SelectionDo not connect to the TV terminal AV Compu Link Remote Control SystemConnect to the terminal indicated Illustration One-Touch Video Play Automatic Selection of TV’s Input ModeAutomatic Power On/Off See page 44 for detailsStarts playback To operate JVC audio components using this remote controlOperating Other Components Starts playingFollowing operations on the VCR To operate JVC video components using this remote controlAfter pressing VCR, you can perform Return TV Volume +TV/VIDEO CATV/SAT in the Power Press and hold CATV/SAT in the Power sectionEnter manufacturer’s code two digits using Release CATV/SAT in the Power sectionOperating Other Manufacturers’ Video Equipment Press and hold VCR in the Power sectionRelease VCR in the Power section Try to operate your VCR by pressing VCR PowerProblem Possible Cause Solution TroubleshootingAmplifier SpecificationsGeneral FM tuner IHFAM tuner EN, FR

RX-665VBK specifications

The JVC RX-665VBK is a versatile and feature-rich audio receiver that has earned recognition for its balanced performance and modern connectivity options. Designed for home theater enthusiasts and music lovers alike, this receiver delivers a powerful audio experience while seamlessly integrating into your existing entertainment setup.

One of the standout features of the RX-665VBK is its robust amplification system. With a total output power of 100 watts per channel, it provides ample power to drive a wide range of speakers, making it suitable for various room sizes. The receiver employs direct energy technology, which enhances efficiency and minimizes distortion, resulting in clear and dynamic sound reproduction across all frequencies.

Connectivity is a strong point for the RX-665VBK, as it comes equipped with multiple HDMI inputs. This allows users to connect various devices such as Blu-ray players, gaming consoles, and streaming devices, all while supporting high-definition video formats. Additionally, the receiver features a dedicated HDMI out for easy connection to your television, ensuring that you can enjoy high-quality audio-visual content without complicating your setup.

Incorporating advanced digital processing technologies, the RX-665VBK supports Dolby Digital and DTS surround sound formats. This enables users to experience immersive audio that complements high-definition video, making it perfect for movie nights and gaming sessions. The receiver also includes a built-in AM/FM tuner, allowing you to listen to your favorite radio stations with ease.

User convenience is further enhanced by the inclusion of an intuitive on-screen display. This feature simplifies the setup process, guiding users through the configuration of speaker settings and audio adjustments. For added flexibility, the RX-665VBK supports multiple audio input options, including USB and auxiliary inputs, enabling seamless playback from various sources.

The JVC RX-665VBK is not just about audio performance; its sleek and modern design ensures it fits well in any living space. With a user-friendly remote control, managing your audio experience is simple and straightforward.

In conclusion, the JVC RX-665VBK stands as a commendable choice for anyone seeking an affordable yet powerful audio receiver. With its combination of impressive amplification, advanced technologies, and modern connectivity options, it caters to the diverse needs of home entertainment enthusiasts, making it a valuable addition to any audio setup.
Top Page Image Contents