JVC RX-665VBK manual Using the DVD Multi Playback Mode

Page 42

Using the DVD MULTI Playback Mode

English

6.Press Control 5/ ∞ until “–REAR L+” appears on the display.

7.Press Control 2 / 3to adjust the left rear speaker output level.

•Pressing Control 2decreases the output level up to –10 dB.

•Pressing Control 3increases the output level up to +10 dB.

8.Press Control 5/ ∞ until “–REAR R+” appears on the display.

9.Press Control 2 / 3to adjust the right rear speaker output level.

•Pressing Control 2decreases the output level up to –10 dB.

•Pressing Control 3increases the output level up to +10 dB.

From the remote control:

1.

Press DVD MULTI until “DVD MULTI” appears on

 

 

 

 

 

 

the display.

 

 

 

 

 

2.

Select the analog discrete output mode on the DVD

 

 

 

 

 

 

player, and start playing a DVD.

 

 

 

 

 

 

Refer to the manual supplied with the DVD player.

 

 

 

 

 

If you want to make any adjustment, go to the following steps.

 

 

 

 

 

3.

Press CENTER +/– to adjust the center speaker

 

 

 

 

 

 

output level.

CENTER

 

• Pressing CENTER – decreases the output level up to –10 dB.

 

 

 

 

 

 

 

 

 

 

 

 

• Pressing CENTER + increases the output level up to +10 dB.

 

 

 

 

 

4.Press REAR (L) +/– to adjust the left rear speaker output level.

•Pressing REAR (L) – decreases the output level up to –10 dB.

•Pressing REAR (L) + increases the output level up to +10 dB.

REAR

(L)

5.Press SOUND CONTROL, then press REAR•R +/– to adjust the right rear speaker output level.

•Pressing REAR•R – decreases the output level up to –10 dB.

•Pressing REAR•R + increases the output level up to +10 dB.

SOUND

CONTROL

100+

– REAR•R +

+10 0

39

Page 41 Page 43
Image 42
Page 41 Page 43
Contents RX-665VBK Mises en garde, précautions et indications diverses For actual setting procedures, see pages 26 to Niveau d’effetTable of Contents Parts Identification Remote Control$ Power buttons CATV/SAT, TV, VCR Audio 14, 45, 46 Front PanelEasy Set Up & Operations For Reproducing Surround Sound with your VCRTurn on the power Easy Set Up & Operations For Reproducing DVD Multi Playback with your DVD playerMake further Locations Getting StartedGeneral Handling the receiverConnecting the FM and AM Antennas FM Antenna ConnectionsAM Antenna Connections Getting Started Connecting the front speakersConnecting the Speakers Connect the front speakers to the Front Speakers terminalsConnecting the rear and center speakers Connecting the subwooferVideo component connections Connecting Audio/Video ComponentsAudio component connections If your audio components have a Compu LINK-3 terminalDVD player connection If your audio components have an AV Compu Link terminalConnecting the Power Cord Putting Batteries in the Remote ControlBasic Operations From the remote controlTurning the Power On and Off On the front panelFrom the remote control only Basic OperationsOn the front panel only Listening with Headphones To listen with only headphonesRecording a Source Listening at Low Volume Loudness Basic SettingsAdjusting the Front Speaker Output Balance Using the Sleep TimerWhen the shut-off time comes To cancel the Sleep TimerReceiver turns off automatically Small Basic SettingsSelecting the Center Speaker Size LargeTo cancel the One Touch Operation function To store the sound settingsTo recall the sound settings One Touch OperationTo store the preset stations Tuning in Stations ManuallyUsing Preset Tuning Receiving Radio BroadcastsTo cancel a stored preset station To tune in a preset stationPress 10 keys to select a preset channel number Selecting the FM Reception Mode Receiving Radio BroadcastsUsing the Preset SEA Modes Selecting Your Favorite SEA ModeTo cancel the preset SEA mode Using the Preset SEA Modes Press SEA Preset to select the effect levelOn the DAP mode Using the Surround ProcessorOn JVC 3D-PHONIC mode On surround modes3DACTION Using the Surround ProcessorUsing JVC 3D-PHONIC Modes 3DTHEATRMark Press Control 2/ 3to adjust the effect levelTo cancel the 3D-PHONIC mode Press Effect to select the effect levelUsing the DAP Modes PavilionHall To cancel the DAP mode Select OFF in step DAP indicator goes off from the displayPress Rear L +/- to adjust the rear speaker Output level Effect Speaker Arrangements for Surround Modes Select Prologic or Theater Select Phantom for center modeSelect 3CHLOGIC Select Normal or Wide for center mode This casePrologic Preparing for Surround ModesPress Surround so that the Control TheaterWide Press Control 2/ 3to select the center modeDelay NormalIf necessary, adjust the speaker output balance as follows Delay 1 Delay 2 DelayPress Effect to adjust the effect level Press Test to start checking the speaker output balancePress Test again to stop the test tone Previous mode is recalled with its previous Using Surround ModesTo cancel Surround mode From the front panelUsing the DVD Multi Playback Mode Speaker arrangements for DVD Multi playbackActivating the DVD Multi playback Using the DVD Multi Playback Mode Automatic Source Selection Compu Link Remote Control SystemRemote Control through the Remote Sensor on the Receiver Synchronized RecordingAV Compu Link Remote Control System Connect to the terminal indicated IllustrationDo not connect to the TV terminal See page 44 for details Automatic Selection of TV’s Input ModeAutomatic Power On/Off One-Touch Video PlayStarts playing To operate JVC audio components using this remote controlOperating Other Components Starts playbackTo operate JVC video components using this remote control After pressing VCR, you can performFollowing operations on the VCR TV Volume + TV/VIDEOReturn Release CATV/SAT in the Power section Press and hold CATV/SAT in the Power sectionEnter manufacturer’s code two digits using CATV/SAT in the PowerTry to operate your VCR by pressing VCR Power Press and hold VCR in the Power sectionRelease VCR in the Power section Operating Other Manufacturers’ Video EquipmentTroubleshooting Problem Possible Cause SolutionSpecifications AmplifierFM tuner IHF AM tunerGeneral EN, FR

RX-665VBK specifications

The JVC RX-665VBK is a versatile and feature-rich audio receiver that has earned recognition for its balanced performance and modern connectivity options. Designed for home theater enthusiasts and music lovers alike, this receiver delivers a powerful audio experience while seamlessly integrating into your existing entertainment setup.

One of the standout features of the RX-665VBK is its robust amplification system. With a total output power of 100 watts per channel, it provides ample power to drive a wide range of speakers, making it suitable for various room sizes. The receiver employs direct energy technology, which enhances efficiency and minimizes distortion, resulting in clear and dynamic sound reproduction across all frequencies.

Connectivity is a strong point for the RX-665VBK, as it comes equipped with multiple HDMI inputs. This allows users to connect various devices such as Blu-ray players, gaming consoles, and streaming devices, all while supporting high-definition video formats. Additionally, the receiver features a dedicated HDMI out for easy connection to your television, ensuring that you can enjoy high-quality audio-visual content without complicating your setup.

Incorporating advanced digital processing technologies, the RX-665VBK supports Dolby Digital and DTS surround sound formats. This enables users to experience immersive audio that complements high-definition video, making it perfect for movie nights and gaming sessions. The receiver also includes a built-in AM/FM tuner, allowing you to listen to your favorite radio stations with ease.

User convenience is further enhanced by the inclusion of an intuitive on-screen display. This feature simplifies the setup process, guiding users through the configuration of speaker settings and audio adjustments. For added flexibility, the RX-665VBK supports multiple audio input options, including USB and auxiliary inputs, enabling seamless playback from various sources.

The JVC RX-665VBK is not just about audio performance; its sleek and modern design ensures it fits well in any living space. With a user-friendly remote control, managing your audio experience is simple and straightforward.

In conclusion, the JVC RX-665VBK stands as a commendable choice for anyone seeking an affordable yet powerful audio receiver. With its combination of impressive amplification, advanced technologies, and modern connectivity options, it caters to the diverse needs of home entertainment enthusiasts, making it a valuable addition to any audio setup.
Top Page Image Contents