Precor S3.23 manual Proper attire when lubricating the Guide Rods

S3.23 Assembly and Maintenance Guide
J. Remove the Weight Pin and gently lower the Top
Cap Weight onto the Weight Stack.
K. Remove the slack in the cable. Use two ⁹⁄₁₆-inch
wrenches to loosen the fastener that holds the
Cam Washer. Rotate the Cam Washer to remove			Top Cap
any slack in the cable. Check the Top Cap Weight			Weight
to make sure it remains well-seated on the Weight
Stack and then wrench tighten the Cam Washer
fasteners.
L. Peel the Weight Label off the Weight Label Strip.
M. Peel the backing off the Weight Label to expose			Weight
the adhesive and place a label on each Weight			Pin
Plate. The recommended location of the label is			5 lb
toward the rear of the unit.
N. Apply one tube of lubricant to each Guide Rod.			Weight
			Stack	Adjust Cam Washer to	Top Cap	Cam
CAUTION: The lubricant can stain clothes. Wear			10 lb	K remove cable slack.	Weight	Washer
proper attire when lubricating the Guide Rods.
			Weight
			Stack
					Lubricant	Guide Rod
Remove Weight Pin and				N
J lower Top Cap Weight.			M
Weight Label Strip
L	35
	40
	45	Weight
	50
		Label
	55		7.5
	60		10
	65		12.5
	70		15
25			17.5
27.5	75		20
30	80		22.5
			25
1		2	3	4	5	6

Step 2. Assemble Weight Stack, Continued

page 12