Cable Adjustments, Selector Stem Adjustments

S3.23 Assembly and Maintenance Guide

1. Cable Adjustments

The Cam Washer ensures easy cable adjustments.

A.To remove the slack in the cable. Use two ⁹⁄₁₆-inch wrenches to loosen the fastener that holds the Cam Washer.

B.Rotate the Cam Washer so that the slack is removed.

C.Check the Top Cap Weight to make sure it remains well-seated on the Weight Stack and then wrench tighten the Cam Washer fasteners.

D.Check the Selector Stem alignment by inserting the Weight Pin into every hole on the Weight Stack.

	B
A	Cam Washer
A	Top Weight
	Assembly
C

2. Selector Stem Adjustments

If the Selector Stem consistently strikes the inside of the weight stack or it is misaligned with the Weight Stack hole, you can re-center the Selector Stem by taking the following steps:

A.To free the Selector Stem, remove the Weight Pin from the Weight Stack.

B.Pull up the Selector Stem and place a cover over the opening in the Weight Stack. Rest the Selector Stem on the cover.

C.Use an 8mm hex key to loosen the socket head bolt in the center of the Top Cap Weight.

Important: Do not remove the socket head bolt.

D.Remove the cover from the Weight Stack and lower the Selector Stem so the Top Cap Weight rests on the Weight Stack.

E.To lock the Selector Stem, insert the Weight Pin into the Weight Plate hole at the bottom of the Weight Stack.

F.Wrench-tighten the socket head bolt in the center of the Top Cap Weight.

G.Check the adjustment by inserting the Weight Pin into every Weight Plate hole. The Weight Pin should slide easily in and out of each Weight Plate and Selector Stem.

H.Insert the Weight Pin into the appropriate Weight Plate for your level of fitness.

J.Replace the Shroud, if necessary.

Adjustments and Maintenance, Continued

page 18