S3.23 Assembly and Maintenance Guide
2Preparations
CAUTION: To set up this unit, you will need assistance. Do not attempt assembly by yourself.
You must review and follow the instructions in this guide. If you do not assemble and use the S3.23 according to the following guidelines, you could void the Precor Limited Warranty.
Required Tools
Tools that you need to obtain before assembling the unit include:
❏Standard set of hex keys
❏Two
❏One
❏Wire tie cutter (cuts plastic tie wraps)
❏Step stool
Note: Use
Installation Requirements
Follow these installation requirements when assembling the unit:
•Fill out and mail the warranty registration card.
•Set up the S3.23 on a solid, flat surface.
A smooth, flat surface under the unit helps keep it level.
•Provide ample space around the machine. Open space around the machine allows for easier access.
•Insert all fasteners in the same direction. For aesthetic purposes, insert all the fasteners in the same direction unless specified (in text or illustrations) to do otherwise.
•Leave room for adjustments. Tighten fasteners (such as screws, nuts, and bolts), so the unit is stable, but leaves room for adjustments. Do not fully tighten fasteners until instructed (in the steps) to do so.
Assembly Tips
•A black
To find out the length of a particular fastener, measure its shank (the long, narrow part beneath the head). Refer to the following diagram:
Fastener head |
|
Fastener threads | To determine the |
length of a fastener, | |
| measure its shank. |
Shank
•Silver fasteners are used within the silver painted areas. Black fasteners are used when assembling the gray painted surfaces.
•Some pieces have extra holes that you will not use. Use only those holes indicated in the instructions and illustrations.
•Read all caution notes on each page before completing that step.
•While you may be able to assemble the S3.23 by reading the illustrations only, refer to the text for important safety cautions and notes.
Preparations
page 5