S3.23 Assembly and Maintenance Guide
3. Attach Shrouds
Two Shrouds are attached to each Main Upright. Complete the assembly steps for one side before moving the other Main Upright.
Important: Handle the Shroud with care.The acrylic Shrouds require special handling as they are easily scratched. For proper care and maintenance, refer to the Adjustments and Maintenance section in this guide.
A.Install the Shrouds so the cutouts allow access to the Weight Stack Pin.
B.Attach a Shroud to each side of the Main Upright using
six
Note: Start at the top two mounts and work toward the base. Ask your assistant to hold the Shroud in place while you insert the top spacers and fasteners. Alternately finger tighten all six fasteners while adjusting the alignment.
C.Wrench tighten all the fasteners using a hex key.
CAUTION: Do not over tighten. You can crack or warp the Shroud if too much pressure is applied to the fasteners.
|
| Shroud | B |
|
|
|
|
|
|
| |
|
|
|
| 6 - 1³⁄₄" Socket head screws per Shroud | |
|
|
| C 6- spacers per Shroud |
| |
Cutout in |
|
|
|
|
|
Shroud |
|
|
|
|
|
1 | 2 | 3 | 4 | 5 | 6 |
Step 3. Attach Shrouds
page 14