Huffy P/N 21147703 manual Pole Sections Should have a

Page 10

3.Align dimple of middle pole with slot of bottom pole. While maintaining alignment, bounce top and middle pole assembly (1 & 2) onto lower pole section (3) as shown until they no longer move toward pole identification mark.

CAUTION!

THE IDENTIFICATION STICKER IS LOCATED 5" FROM THE END OF THE POLE. WHEN PROPERLY POUNDED TOGETHER, THE POLE SECTIONS SHOULD HAVE A 3-1/2"

MINIMUM OVERLAP, LEAVING 1- 1/2" BETWEEN THE OVERLAPPING POLE AND THE IDENTIFICATION STICKER.

NOTE:

POLE SECTIONS

SHOULD HAVE A

3-1/2" (9 CM) MINIMUM

OVERLAP.

1

POLE

IDENTIFICATION

MARK

2

3

WOOD SCRAP

(NOT SUPPLIED)

2

5"

Bottom Pole

IDENTIFICATION

3

STICKER

2

IDENTIFICATION

1-1/2"

Bottom Pole

STICKER

 

3

RODS SHOWN ARE

FOR VISUAL

REPRESENTATION

OF ALIGNMENT

AND ARE NOT

SUPPLIED WITH

THE HARDWARE

IMPORTANT!:

Holes in top (1) and bottom pole (3) sections MUST align to correctly position elevator system toward playing surface.

P/N 21147703 03/04

10

Image 10
Contents Portable Basketball System 21147703 03/04 Safety Instructions Front Back Qty Description Hardware Identifier Bolts & Screws Height Adjustment Before YOU Start Section a Assemble the Poles LabelPole Sections Should have a Section B Assemble the Base AND/ORDo not Over Tighten 03/04 21147703 03/04 Section C Assemble the Elevator & Backboard Socket Wrenches and Sockets 9/16 3/421147703 03/04 FIG. a Face of Backboard Toward Board Upper Elevator tube Lower Elevator tube Pole Tighten ALL Hardware From 8 After This Assembly is Completed 03/04 USE EYE Protection Section D Securing the System Section E Install Front Cover FIG.ASection F NET Installation Install clipsInsert net into bottom of clip as shown Height Adjustment Section G Apply Height and Moving LabelSection H Height Adjustment