Huffy P/N 21147703 manual Do not Over Tighten

Page 12

1.Assemble pole bracket (12) to pole (3) using bolt (13) and locknut (14) as shown.

2.Attach pole assembly to base using carriage bolts (15) washers(10) and nuts (11) as shown. Two people are required for this step.

13

14

WARNING!

TWO PEOPLE REQUIRED FOR THIS PROCEDURE. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE.

IMPORTANT!:

THE CUT CORNERS OF THE POLE BRACKET NEED TO FACE TOWARD THE BACK OF THE BASE AS SHOWN.

12

IMPORTANT!:

DO NOT OVER

TIGHTEN

15

10 11

P/N 21147703 03/04

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Portable Basketball System 21147703 03/04 Safety Instructions Front Back Qty Description Hardware Identifier Bolts & Screws Height Adjustment Before YOU Start Section a Assemble the Poles LabelPole Sections Should have a Section B Assemble the Base AND/ORDo not Over Tighten 03/04 21147703 03/04 Section C Assemble the Elevator & Backboard Socket Wrenches and Sockets 9/16 3/421147703 03/04 FIG. a Face of Backboard Toward Board Upper Elevator tube Lower Elevator tube Pole Tighten ALL Hardware From 8 After This Assembly is Completed 03/04 USE EYE Protection Section D Securing the System Section E Install Front Cover FIG.ASection F NET Installation Install clipsInsert net into bottom of clip as shown Height Adjustment Section G Apply Height and Moving LabelSection H Height Adjustment
Top Page Image Contents