Huffy P/N 21147703 manual Height Adjustment

Page 7

HARDWARE IDENTIFIER (PLASTIC SPACERS & CAPS)

Item #46 (4)

Item #17 (1)

Item #7 (2)

Item #20 (8)

Item #49 (4)	Item #24 (2)

HEIGHT ADJUSTMENT

TO ADJUST BACKBOARD:

		1
1.	While holding handle, remove pin.	3
2.	Move elevator up or down to
	desired height.	2

3. Replace pin full length to lock system at desired height.

2

MOVING SYSTEM

1.	Adjust basketball backboard
1	height to lowest position.
2.	While holding pole, rotate
	basketball system forward
	until wheels engage with
	ground.
3.	Move basketball system to
2	desired location.
2
4.	Carefully rotate basketball
3	system upright.
4
5.	Reattach ground restraint and
	check system for stability.
	201252	2/99

Item #42 (1)

7

03/04

P/N 21147703

Image 7

Contents Portable Basketball System 21147703 03/04 Safety Instructions Front Back Qty Description Hardware Identifier Bolts & Screws Height Adjustment Before YOU Start Label Section a Assemble the PolesPole Sections Should have a AND/OR Section B Assemble the BaseDo not Over Tighten 03/04 21147703 03/04 Socket Wrenches and Sockets 9/16 3/4 Section C Assemble the Elevator & Backboard21147703 03/04 FIG. a Face of Backboard Toward Board Upper Elevator tube Lower Elevator tube Pole Tighten ALL Hardware From 8 After This Assembly is Completed 03/04 USE EYE Protection Section D Securing the System FIG.A Section E Install Front CoverInstall clips Section F NET InstallationInsert net into bottom of clip as shown Section G Apply Height and Moving Label Height AdjustmentSection H Height Adjustment