Huffy P/N 21147703 manual Section G Apply Height and Moving Label, Height Adjustment

Page 27

SECTION G: APPLY HEIGHT AND MOVING LABEL

1.Apply Height Adjustment and Moving Label (42) to front of pole, where it is clearly visible.

42

HEIGHT ADJUSTMENT

TO ADJUST BACKBOARD:

			1
1. While holding handle, remove pin.		3
2. Move elevator up or down to
desired height.		2
3. Replace pin full length to lock
system at desired height.
		2
MOVING SYSTEM
1.	Adjust basketball backboard
1	height to lowest position.
2. While holding pole, rotate
	basketball system forward
	until wheels engage with
	ground.
3. Move basketball system to
2	desired location.
2
4.	Carefully rotate basketball
3	system upright.
4
5. Reattach ground restraint and
	check system for stability.
		201252	2/99

27

03/04

P/N 21147703

Image 27

Contents Portable Basketball System 21147703 03/04 Safety Instructions Front Back Qty Description Hardware Identifier Bolts & Screws Height Adjustment Before YOU Start Label Section a Assemble the PolesPole Sections Should have a AND/OR Section B Assemble the BaseDo not Over Tighten 03/04 21147703 03/04 Socket Wrenches and Sockets 9/16 3/4 Section C Assemble the Elevator & Backboard21147703 03/04 FIG. a Face of Backboard Toward Board Upper Elevator tube Lower Elevator tube Pole Tighten ALL Hardware From 8 After This Assembly is Completed 03/04 USE EYE Protection Section D Securing the System FIG.A Section E Install Front CoverInstall clips Section F NET InstallationInsert net into bottom of clip as shown Section G Apply Height and Moving Label Height AdjustmentSection H Height Adjustment