Huffy P/N 21147703 manual Section a Assemble the Poles, Label

Page 9

SECTION A: ASSEMBLE THE POLES

1. Correctly identify each pole section.

I.D. Label

2

1

3

WARNING

I.D. Label

LABEL

 

Align dimple of top pole with slot of middle pole. While maintaining alignment, bounce middle pole

2. (2) into top pole section (1) using a wood scrap as shown until top pole no longer moves toward pole identification mark on middle pole.

 

CAUTION!

 

THE IDENTIFICATION STICKER IS

 

LOCATED 5" FROM THE END OF

 

THE POLE. WHEN PROPERLY

 

POUNDED TOGETHER, THE POLE

 

SECTIONS SHOULD HAVE A 3-1/2"

 

MINIMUM OVERLAP, LEAVING 1-

 

1/2" BETWEEN THE OVERLAPPING

 

POLE AND THE IDENTIFICATION

 

STICKER.

IDENTIFICATION

2

STICKER

 

 

pole middle

 

5"

1

 

 

2

IDENTIFICATION

 

STICKER

 

 

pole middle

 

1-1/2"

1

NOTE:

POLE SECTIONS

SHOULD HAVE A

3-1/2" (9 CM) MINIMUM

OVERLAP.

POLE

IDENTIFICATION

MARK

2

1

WOOD SCRAP

(NOT SUPPLIED)

9

03/04

P/N 21147703

Image 9
Contents Portable Basketball System 21147703 03/04 Safety Instructions Front Back Qty Description Hardware Identifier Bolts & Screws Height Adjustment Before YOU Start Label Section a Assemble the PolesPole Sections Should have a AND/OR Section B Assemble the BaseDo not Over Tighten 03/04 21147703 03/04 Socket Wrenches and Sockets 9/16 3/4 Section C Assemble the Elevator & Backboard21147703 03/04 FIG. a Face of Backboard Toward Board Upper Elevator tube Lower Elevator tube Pole Tighten ALL Hardware From 8 After This Assembly is Completed 03/04 USE EYE Protection Section D Securing the System FIG.A Section E Install Front CoverInstall clips Section F NET InstallationInsert net into bottom of clip as shown Section G Apply Height and Moving Label Height AdjustmentSection H Height Adjustment