7.2 TROUBLESHOOTING |
| |
|
|
|
| PROBLEM | CAUSE / SOLUTION |
|
| Check to see that the power cord is fully plugged into the back of the product and into the |
|
| wall. Make sure the power cord is fully seated into the back of the product. |
| No power. | You may be in “Energy Saver Mode”. Press the “Energy Saver” button to see if the con- |
| sole turns on. | |
|
| |
|
| Verify that all customer assembly connections are working properly. Unplug and |
|
| each connection to verify. Look to see if any cables were pinched during assembly. |
|
| Potential reasons for the wireless heart rate not to work properly include: |
|
| The wireless heart rate is turned OFF in the Settings Menu. Enter the Settings |
|
| Menu and verify that WIRELESS HR is turned ON. |
| Wireless heart rate is | There is poor contact between the telemetry heart rate strap and the skin. |
|
| |
| not working. | There is electrical interference from electrical appliances with the telemetry heart |
|
| rate strap from fluorescent lights, kitchen appliances, etc. Move the product to a |
|
| different location or move electrical appliances away from the product. |
|
| The battery in the Heart Rate Telemetry Strap needs to be replaced. The battery |
|
| is a CR2032 (3V). |
|
|
|
|
| Use of personal electronic devices, such as cell phones and portable mp3 players, cause |
| Heart rate reading is | external noise interference. |
| initially detected and | Equipment is in close proximity to other sources of noise such as audio / video equip- |
| functioning normally but | |
| ment, fans, two way radios, and high voltage/high current power line. | |
| then is lost. | |
| Remove the source of noise or reposition the exercise equipment. | |
|
| |
|
| Be sure to grasp the sensors firmly and keep hands still. If heart rate seems substantially |
|
| higher or lower than expected, remove hands from sensors until heart rate disappears. |
|
| Tips for contact heart rate: |
|
| Dry hands to prevent slipping on the sensors. |
| Contact heart rate | Apply hands to all four sensors (two in each hand). |
| sensors are not reading | |
| Grasp sensors firmly. | |
| my heart rate correctly. | |
|
| Apply constant pressure to the sensors. May need to wait longer for heart rate to |
|
| display. |
|
| Note: The heart rate hand pulse sensors provide an approximate heart rate value. The |
|
| sensors are not medical devices and should not be used in any type of medical applica- |
|
| tion. |
32