Weider 831.153932 user manual 100 102 121

24.Remove the preattached 90mm Pulleys (78) from the Offset Double “U”-bracket (61).

Wrap the Swivel Cable (17) around a 90mm Pulley (78). Attach the Pulley to the Offset Double “U”- bracket (61) with an M10 x 45mm Bolt (93) and an M10 Nylon Locknut (87).

25.Wrap the Swivel Cable (17) around a 90mm Pulley (78). Attach the Pulley and a Cable Trap (68) to the next to bottom hole in the Small Pulley Plates (31) with an M10 x 50mm Bolt (100) and an M10 Nylon Locknut (87). Make sure the Cable Trap is turned to hold the Cable in the groove of the Pulley.

26.Wrap the Swivel Cable (17) around a 90mm Pulley (78). Attach the Pulley and a long Cable Trap (102) to the bracket on the Swivel Upright (5) with an M10 x 50mm Bolt (100) and an M10 Nylon Locknut (87). Make sure the Cable Trap is turned to hold the Cable in the groove of the Pulley.

27.Attach the end of the Swivel Cable (17) to the bracket on the Swivel Carriage (46) with an M10 x 20mm Bolt (13) and an M10 Nylon Locknut (87).

28.Locate the Lat Cable (88), which is 2310mm long and has a ball on one end and an eyelet on the other. Route the eyelet end of the Cable up through the Butterfly Top Frame (7) and around a 90mm Pulley (78). Attach the Pulley inside of the Butterfly Top Frame with an M10 x 67mm Bolt (121), two M10 Washers (91), two 12.5 Spacers (89), and an M10 Nylon Locknut (87).

24
		17
		78
		93
		87
		61
25
		31	100
		87
		78
		68
		17
26		100
		5
	102
	87
		17
		78
27
	46
	87	13
		17
28
	87	78
	91
	89	89
	7	91	121
		88

13