Nylon Locknuts yet | Weider 831.153932 manual

57.Attach the Seat (16) to the Seat Frame (8) with two M6 x 16mm Screws (114), an M6 x 65mm Screw (99), and an M6 Washer (97).

58.Attach the Butterfly Backrest (15) to the Butterfly Upright (3) with four M6 x 16mm Screws (114).

59.Wet one end of the Squat Arm (32) and inside of a Short Pad (20) with soapy water. Slide the Pad (20) onto the Squat Arm as shown.

Attach the Squat Handle (33) to the Squat Arm (32) with two M8 x 20mm Button Head Screws (51). Slide a 50mm Outer Cap w/Hole (111) onto the Squat Handle and press it onto the end of the Squat Arm. Slide the Short Pad (20) over the Screws.

Wet the Squat Handle with soapy water. Slide an 200mm Handgrip (84) onto the Squat Handle.

Repeat this step with the other end of the Squat Arm (32).

60.Attach the Squat Arm (32) to the Squat Bracket (37) with two M10 x 65mm Carriage Bolts (110) and two M10 Nylon Locknuts (87). Do not tighten the

Nylon Locknuts yet.

Finish attaching the Squat Arm (32) to the Squat Bracket (37) with two M10 x 70mm Carriage Bolts (108), two M10 Washers (91), and two M10 Nylon Locknuts (87).

Tighten all of the M10 Nylon Locknuts (87) used in this step.

57
	16
		8
		97
		114
		99
58			114
	15		3
			114
59		20
	32	20
	32
		51
		20
		51
			33
			111
		84
60		87
	87	91
		91
	32
			110
		108	37

57
	16
		8
		97
		114
		99
58			114
	15		3
			114
59		20
	32	20
	32
		51
		20
		51
			33
			111
		84
60		87
	87	91
		91
	32
			110
		108	37

57
	16
		8
		97
		114
		99
58			114
	15		3
			114
59		20
	32	20
	32
		51
		20
		51
			33
			111
		84
60		87
	87	91
		91
	32
			110
		108	37

57
	16
		8
		97
		114
		99
58			114
	15		3
			114
59		20
	32	20
	32
		51
		20
		51
			33
			111
		84
60		87
	87	91
		91
	32
			110
		108	37