Weider Pro 2250 user manual Frame Assembly, Make Things Easier for Yourself, Locknuts yet

Page 5

ASSEMBLY

Make Things Easier for Yourself

Everything in this manual is designed to ensure that the weight system can be assembled suc- cessfully by anyone. However, it is important to realize that the weight system has many parts and that the assembly process will take time. Most people find that by setting aside plenty of time, assembly will go smoothly.

Assembly requires two people.

Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

Tighten all parts as you assemble them, unless instructed to do otherwise.

As you assemble the weight system, make sure all parts are oriented as shown in the drawings.

For help identifying small parts, use the PART IDENTIFICATION CHART at the center of this manual.

The following tools (not included) are required for assembly:

• Two adjustable wrenches

• One rubber mallet

• One standard screwdriver

• One Phillips screwdriver

Lubricant, such as grease or petroleum jelly, and soapy water.

Assembly will be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches.

1.

Frame Assembly

Before beginning assembly, make sure that you have read and understand the informa- tion in the box above.

For help identifying small parts, use the PART IDENTIFICATION CHART in the cen- ter of this manual.

1

3

4

79

79

1

Attach a Stabilizer Foot (51) to the Stabilizer (5) with two #8 x 3/4” Screws (56).Attach another

Stabilizer Foot in the same manner.

Press two 2” x 3” Inner Caps (79) into the Base

(4).

Insert two 5/16” x 2 3/4” Carriage Bolts (14) up through the Stabilizer (5). Insert two 5/16” x 2 1/2” Carriage Bolts (1) up through the Base (4). Note:

It may be helpful to place a piece of tape over the bolt heads to hold the Bolts in place.

Attach the Base (4) to the Stabilizer (5) with the two 5/16” x 2 3/4” Carriage Bolts (14) and two 5/16” Nylon Locknuts (3).Do not tighten the

Locknuts yet.

51

5

 

 

51

 

14

 

56

5

Image 5
Contents Sears, Roebuck and Co., Hoffman Estates, IL Model No Serial NoTable of Contents Decal Important PrecautionsFor your benefit, read this manual carefully before Before YOU BeginRight Side Left SideFrame Assembly AssemblyMake Things Easier for Yourself Stabilizer Foot in the same mannerTighten the 5/16 Nylon Locknuts 3 used in step Assemble the other Press Arm 73 in the same manner Arm AssemblyTighten the 5/16 Nylon Locknuts 3 used in steps 2 Trap is turned to hold the Cable in the groove of the Pulley Cable AssemblyHook Ball Page Seat Assembly Page Attaching the Accessories AdjustmentsChanging the Weight Setting Attaching the LEG Lever to the LOW Pulley Station Attaching and Removing the SeatWeight Resistance Chart Tightening the Cables TroubleshootingLong Cable Short Cable Cable DiagramsExercise Guidelines Staying Motivated Muscle ChartCooling Down Key No. Qty Description Part LIST-Model NoExploded DRAWING-Model No Part Identification CHART-Model No .159300 R0903A Page Sears, Roebuck and Co., Dept 817WA, Hoffman Estates, IL Full 90-DAY Warranty