ARM ASSEMBLY
CABLE ASSEMBLY
17.Press a 1 3/4Ó Square Inner Cap (48) into the lower end of the Left Fly Arm (6). Wet the lower end of the Left Fly Arm with soapy water. Slide a 10Ó Pad (22) onto the Left Arm.
Repeat this step with the Right Fly Arm (5).
18.Locate and open the parts bags labeled ÒCABLE ASSEMBLYÓ and ÒPULLEYS.Ó
During steps 19 through 45, refer to the CABLE DIAGRAMS on pages 25 and 26 of this manual to verify proper cable routing. Before beginning this section, fully unwind the five Cables and identify the Cables by com- paring the lengths and the ends. The approxi- mate length of each Cable, in inches, is listed after the key number in the drawing.
IMPORTANT: While assembling the cables, do not over tighten the bolts and nuts attaching the pulleys. The pulleys must be able to turn freely.
19.Insert a 5/16Ó x 1Ó Bolt (51) through the brack- et on the Right Fly Arm (5). Tighten a 5/16Ó Nylon Jam Nut (90) onto the Bolt.
Identify the Butterfly Cable (88)Ñthis is the second shortest Cable. Slide one end of the Butterfly Cable onto the 5/16Ó x 1Ó Bolt (51).
Thread another 5/16Ó Nylon Jam Nut (90) onto the Bolt, but do not fully tighten it.
Leave enough room between the two Jam Nuts for the Cable to pivot.
11
17 |
|
| 6 |
5 |
|
| 48 |
22 | 22 |
18 |
|
| 86Ñ71 1/2Ó |
| 88Ñ82 3/16Ó |
| 84Ñ99 5/8Ó |
| 85Ñ110Ó |
| 87Ñ212 1/2Ó |
19 |
|
| 90 |
| 88 |
| 5 |
| 51 |