Weider 9300 PRO user manual Misc

SEAT ASSEMBLY

50.Press two 3/4Ó Round Inner Caps (78) into each Pad Tube (28).

Insert a Pad Tube (28) into the Rear Seat Frame (16). Slide a Foam Pad (29) onto each end of the Pad Tube.

Insert the other Pad Tube (28) into the Leg Lever (15). Slide a Foam Pad (29) onto each end of the Pad Tube.

51.Attach the Large Backrest (19) to the Press Upright (4) with two 1/4Ó Washers (37) and two 1/4Ó x 2 1/2Ó Machine Screws (64).

Remove the ÔWEIDER 9300 PROÕ decal from the backing paper and apply the decal to the Press Upright (4) above the warning decal, where shown.

52.Insert a 1/4Ó x 2 1/2Ó Carriage Bolt (60) into a Seat Plate (41). Attach the Seat Plate to the Seat (17) with two 1/4Ó x 3/4Ó Screws (59).

Attach the Seat (17) to the Seat Frame (8) with a 1/4Ó Washer (37) and a 1/4Ó x 2 1/2Ó Machine Screw (64). Slide a 1/4Ó Washer (37) onto the 1/4 x 2 1/2Ó Carriage Bolt (60) and tighten a 1/4Ó Nylon Locknut (44) onto the Carriage Bolt.

See the inset drawing. Attach the Curl Pad (11) to the Curl Pad (10) with two 1/4Ó x 3/4Ó Screws (59).

50
	78				16
		29
					28
		15			29
					78
51					WEIDER 9300
				4	PRO decal
					19
	64	37
52					17
					60
59					41
					59
			11		37
		10			64
					44

MISC.

53.Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in HOW TO USE THE TRAINING SYSTEM, beginning on page 21 of this manual.

Before using the training system, pull each cable a few times to be sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPOR-

TANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAMS on page 25 and 26 of this manual for proper cable routing. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See TROUBLE-SHOOTING AND MAINTENANCE on page 24.

20