Weider 9300 PRO user manual Òframe Assembly BAG TWO.Ó, Do not tighten the Nylon Locknuts yet

FRAME ASSEMBLY

1.

Before you begin this step, make sure that you have read all of the information on page 5. This brief introduction will save you much more time than it takes to read it!

Locate and open the parts bags labeled ÒFRAME ASSEMBLY BAG ONEÓ and

ÒFRAME ASSEMBLY BAG TWO.Ó

Press two 2Ó Square Outer Caps (58) onto the Weight Base (14) in the indicated locations. Press a 2Ó Square Inner Cap (56) into the end of the Weight Base.

Insert two 5/16Ó x 2 1/2Ó Carriage Bolts (49) up through the Weight Base (14). Insert four 5/16Ó x 2 1/2Ó Carriage Bolts (49) up through the Press Base (13).

Press a 2Ó Square Inner Cap (56) into the end of the Press Base (13). Attach the Press Base to the Weight Base (14) with two 5/16Ó x 2 3/4Ó Bolts (55), two 5/16Ó Washers (20), and two 5/16Ó Nylon Locknuts (40).

2.Slide the Ab Upright (1) onto the indicated 5/16Ó x 2 1/2Ó Carriage Bolts (49) in the Weight Base (14). Hand tighten two 5/16Ó Nylon Locknuts (40) onto the Carriage Bolts.

Do not tighten the Nylon Locknuts yet.

Slide the Press Upright (4) onto the indicated 5/16Ó x 2 1/2Ó Carriage Bolts (49) in the Press Base (13). Hand tighten two 5/16Ó Nylon Locknuts (40) onto the Carriage Bolts. Do not tighten the Nylon Locknuts yet.

3.Press two 2Ó Square Inner Caps (56) into the ends of the Top Frame (2). Press two 2Ó Square Inner Caps (56) into the indicated sides of the Butterfly Frame (3). Press two 1Ó Inner Caps (65) into the top of the Butterfly Frame.

Attach the Butterfly Frame (3) to the Top Frame (2) with a 5/16Ó x 3Ó Bolt (91), 5/16Ó Flat Washers (20), and a 5/16Ó Nylon Jam Nut (90). Be sure that the Bolt is on the side shown.

Finish attaching the Butterfly Frame (3) to the Top Frame (2) with a 5/16Ó x 2 3/4Ó Bolt (55), 5/16Ó Flat Washers (20), and a 5/16Ó Nylon Locknut (40).

6

1
	58	58
	55
14	20	13
	40
	49
56		49	56
2
1			4
40			40
	14		13
	49	49
3	90		56
	20
	40
2	20	91	65	56
	55			3
56		56