Weider 9300 PRO user manual Cable Diagrams

Page 25

CABLE DIAGRAMS

The cable diagrams on this page and the next page show the proper routing of the Press Cable (87), the Ab Cable (85), the Butterfly Cable (88), the High Cable (84), and the Rear Cable (86). Use the diagrams to be sure that the Cables have been assembled correctly. The starting and ending points of each Cable have been labeled. The numbers show the proper route for each Cable. IMPORTANT: If the Cables have not been cor- rectly routed, the training system will not function properly and damage may occur.

Press Cable (87)

Ab Cable (85)

10ÑLarge ÒUÓ Bracket

7

 

6

 

4

5

 

 

3

9

 

8

 

2

 

 

1

 

25

3

Ab PulleyÑ1

2

4ÑLow Pulley

Butterfly Cable (88)

4

5ÑLeft Arm

2

 

1ÑRight Arm

 

3

 

Image 25
Contents Model No. WESY29100 Serial No QUESTIONS?Customer HOT Line Limited Warranty Table of ContentsImportant Precautions Decal Before YOU BeginMake Assembly Easier for Yourself AssemblyDo not tighten the Nylon Locknuts yet Òframe Assembly BAG TWO.ÓLocknuts yet Weight Tubes are in the pin grooves in the upper Weights Òarm ASSEMBLY.Ó Frame Assembly ARM AssemblyARM Assembly ARM Assembly Cable Assembly Cable Assembly Cable Assembly Cable Trap is turned to hold the Cable Place Identify the Press Cable 87Ñthis isCable Assembly Trap is turned to hold the Cable in place Cable Assembly Be sure that the Cable Trap is in the indi- cated position Òseat ASSEMBLY.Ó Seat AssemblyMisc Changing the Weight Setting HOW to USE the Training SystemAttaching the AB Strap to the AB Pulley Station Adjusting the Curl PADAttaching the LEG Lever to the LOW Pulley Station Plates Weight Resistance ChartTightening the Cables TROUBLE-SHOOTING and MaintenanceCable Diagrams Page Page Part Identification CHARTÑModel No. WESY29100 Page 7/8 Plastic Bushing Qty Description Part LISTÑModel No. WESY29100Exploded DRAWINGÑModel No. WESY29100 Ordering Replacement Parts