Weider 8510 user manual Cable Assembly

CABLE ASSEMBLY

15.Route the Long Cable (23) around the ÒVÓ- Pulley (6) on the Right Arm (48). Be sure that the Cable is in the groove of the ÒVÓ- Pulley and that the Long Cable Trap (50) is turned to hold the Cable in place. Tighten the 3/8Ó x 2 1/2Ó Bolt (7) and the 3/8Ó Nylon Locknut (not shown).

16.Route the Long Cable (23) around the 3 1/2Ó Pulley (15) attached to the Pulley Bracket

(20).Be sure that the Cable is in the groove of the Pulley and that the Cable Trap (66) is turned to hold the Cable in place. Tighten the 3/8Ó x 2Ó Bolt (12) and the 3/8Ó Nylon Locknut (not shown).

Be sure that the 5/16Ó x 5Ó Bolt (68) is proper- ly tightened and that the Pulley Bracket (20) can move freely.

17.See the inset drawing. Attach a 3 1/2Ó Pulley

(15)and a Cable Trap (66) to the indicated hole in the Long ÒUÓ-Bracket (57) with a 3/8Ó x 2Ó Bolt (12) and a 3/8Ó Nylon Locknut (21). Be sure that the Cable Trap is inside the ÒUÓ- Bracket. Note: This may come pre-assem- bled.

Route the Long Cable (23) around the 3 1/2Ó Pulley (15) and through the Long ÒUÓ-Bracket (57). Be sure that the Cable is in the groove of the Pulley and that the Cable and Pulley move smoothly.

18.Note: The Pulley (15) in this drawing is pre-assembled. It is shown disassembled for easy part identification.

Route the Long Cable (23) around the 3 1/2Ó Pulley (15) attached to the bracket on the Top Frame (55). Tighten the 3/8Ó x 2Ó Bolt (12) and the 3/8Ó Nylon Locknut (21). Be sure that the Cable is in the groove of the Pulley and that the Cable and Pulley move smoothly.

15	50	7
		6

48

23

16 68 66

20
12
23	15

17

23 23

15

66

12

21

57

18		23	15
	Bracket
			12

55

21

10